TV menu-Installation
Select the menu language
1Press the MENU button on the remote control.
Settings
InstallationLanguage2Use the cursor down to select Installation in the Settings menu.
LanguageEnglish3Use the cursor right to enter the Installation menu.
AutoprogramFrançais
4Select Language and enter the list of available languages with the
SourceEspanol
cursor right.
Clock
Weak channel installation5Select your preferred language with the cursor up/down and press
Current software infothe OK button to conA rm your selection.
Reset AV settings6Proceed with the Installation menu.
Info
Store TV channels
1Select Autoprogram in the Installation menu.
2Use the cursor right to enter the Autoprogram menu.
3Select Cable or Antenna in the Installation mode.
Settings I Installation
AutoprogramAntennaWhen Antenna is selected, the TV will detect antenna
Antennasignals and will search for antenna TV (NTSC and ATSC) channels
CableStart nowavailable in your local area.
When Cable is selected, the TV will detect cable company
supplied signals and will search for cable TV (NTSC, ATSC, QAM
modulated) channels available in your area.
Make sure that registration with your cable TV provider and
connection of equipment are completed.
Info
4Select Start now with the cursor right key.
5Press the OK button.
6Press the green bSuttatrotn ? to start Autoprogramming. The
menu screen disappears and the progress of Autoprogramming
is displayed. The progress bar indicates the number of analog and
Television Installation
digital TV channels found.
You can now start automatic installation. This
procedure can take more than half an hour.
Auto programming may take up to 20 minutes to complete. Digital
channels will take longer than Analog to nd and program. Please
wait until you see the Auto Programming complete message. The
TV will then switch automatically to the rst channel found.
PreviousStartNote: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. (p. 25)
Notes:
When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in
order to complete Autoprogramming.
When channel update is interrupted, the new updated channel information is retained along with the old un-updated
channel information.
Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.
If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies
and update information.
Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus
optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 13.)
Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
If Antenna/cable signal is interrupted more than 30 minutes, TV will go into off mode. You are requested to press Power button
o r CH + / - button to turn on the TV.
12 |