6gb33005.fm5 Page 34 Tuesday, September 11, 2001 9:53 AM
USING THE HOOD
Switch on the hood a few minutes before starting to cook and leave it running for at least 5 minutes after you have
finished.
1. Pull out the steam deflector (depending on model). This improves hood performance.
2. Turn the speed selector to the required speed setting according to the quantity of fumes and steam to be
extracted.
3. Switch off the hood 5 minutes after you have finished cooking.
4. Close the steam deflector (where fitted).
CARE AND MAINTENANCE
Always disconnect the hood by switching off the electrical power supply before cleaning or
carrying out maintenance.
Grease filter
? The sponge grease filter should be washed in hot soapy water once a month (soak for 1-2 hours, do not wring.
If necessary, repeat the process. Replace with a new filter every 5-6 washes).
? The grease filter paper should be replaced at least once a month.
? Grease filter paper with indicator should be replaced at least every two months or whenever the colour
becomes visible through the holes of the grille.
The paper filter is coloured on one side. This colour should not be visible through the grille holes when the filter
is installed.
? The metal grease filter has an unlimited life and should be washed once a month by hand or in a dishwasher
(60°C) with appropriate detergents.
Leave filter to dry before remounting it.
Whenever cleaning or replacing the grease filters, clean all other exposed parts of the hood.
Carbon filter
(?Air recirculation mode?, see following page)
The carbon filter cannot be washed or regenerated.
Replace the carbon filter (normal usage)
every 6 months (Rectangular carbon filter)
every 4 months (Circular carbon filter).
Replacing bulbs
1. Pull out the steam deflector (depending on model).
2. Open the grille or light fixture and remove the grease filter.
3. Remove the burnt-out bulb and replace it with a new one of the same wattage. Close the grille, light fixture or
metal grease filter.
Cleaning the hood
Use a soft cloth with methylated spirits or a mild liquid detergent. Never use abrasive substances.
Warning! Failure to observe the instructions for cleaning the appliance and replacing or washing the filters may
cause a fire.
TROUBLESHOOTING GUIDE
Hood does not work:Light does not work:
? Is the electrical power supply switched on?? Does the bulb need to be replaced?
? Is there a power failure?? Is the bulb correctly fitted?
? Has the fuse blown?? Is the mains fuse OK?
Insufficient suction power:Never try to carry out any repair by yourself other
? Did you set the right speed?than fixing the above-mentioned problems.
? Do the filters need to be cleaned or replaced?
? Are the air outlets blocked?
34 |
ACEC
WHIRLPOOL
