SPECIFICATIONS* (continued)
Input Clipping Level. ... BAL LO IMP 700 mV to 21 mV Frequency Response ... 22 dB, 40 to 20,000 Hz, BAL LO
(INPUT ATTEN IMP INPUT to SPEAKER OUT-
-30 to 0) PUTS
HI IMP 10V to 335 mV (INPUT
Hum and Noise
ATTEN -30 to 0)
(20 Hz to 20 kHz). .... -127 dBV equivalent input (BAL
AUX 30V to 10V (VOLUME
LO IMP)
from 0 to 10)
Voltage Gain ......... .94 dB BAL LO IMP INPUT to Noise
SPEAKER OUTPUTS (300 Hz to 20 kHz). ... -128 dBV equivalent input (BAL
LO IMP)
71 dB HI IMP INPUT to SPEAKER
OUTPUTS Signal-to-Noise Ratio .. .Greater than 80 dB (below full
43 dB AUX INPUT to SPEAKER output) at typical control set-
OUTPUTS (700; 706: 49 dB) tings (orange marks, MASTER
at 5, INPUT ATTEN at -12)
64 dB BAL LO IMP INPUT to MIX
OUTPUT Mic lnput Simplex
77 dB BAL LO IMP INPUT to Power ............ .24 Vdc open-circuit, 1.8k series
MONITOR OUTPUT resistance, simplex onloff
74 dB BAL LO IMP INPUT to switch
EFFECTS OUTPUT
Power Requirements .. .Models 700 and 706: 120 Vac
16 dB BAL LO IMP INPUT to MIC f lo%, 50160 Hz; 1100W (700),
OUTPUT 600W (706) max. (Can be re-
58 dB BAL LO IMP INPUT to AUX wired for other voltages; see
OUTPUT OPERATION AT OTHER VOLT-
AGES); Models 700E6 and
81 dB BAL LO IMP INPUT to
706E6: 100, 120, 140, 200, 220
HEADPHONE OUTPUT
and 240 volts, 50160 Hz (switch-
0 dB EQ INPUT to EQ OUTPUT
selectable).
30 dB PA INPUT to SPEAKER
Environmental
OUTPUTS
Conditions
Operating ......... .-7" to 43°C (20" to 110°F)
Storage ........... .-40" to 74°C (-40" to 165°F)
Levels and Impedances
Nominal Maximum Actual Working Overall Dimensions. ... .l9O mm H x 584 mm W x 508 mm
Circuit Level Level Impedance Impedance D (7% in. x 23 in. x 20 in.)
BAL LO IMP INPUT 5 mV 700 mV lk 19-300 ohms
Weight .............. .700: 21.3 kg (47 Ib)
HI IMP INPUT 50 mV 10V 145k lOOk or less 706: 17.9 kg (39% Ib)
AUX INPUT 0.5V 30V 50k 10k or less
Construction ......... .Molded construction with black
MIX OUTPUT 1V 9V 2.4k 2k or more
finish, carrying handle, molded
EFFECTS OUTPUT 1V 9V 2.4k 2k or more
rubber feet, line cord storage
MONITOROUTPUT 1V 9V 2.4k 2k or more
Certifications ........ .Listed by Underwriters' Labora-
EQ INPUT 1V 1OV 50k 10k or less
tories, Inc.; listed by Canadian
EQ OUTPUT 1V 9V 2.4k 2k or more
Standards Association as Cer-
AUX OUTPUT 1V 9V 5k 2k or more
tified (700, 706)
MIC OUTPUT 5 mV 75 mV 70 ohms 19-300 ohms
*Measurement Conditions (unless otherwise specified): All volume and gain
PA INPUT 1V 1OV 50k 10k or less controls for measured channel at maximum; unused channel controls at 0;
equalization controls at 0. Measured input terminated as follows (unused
SPEAKER OUTPUT - 28.3V - 4 ohms or more inputs unterminated): BAL LO IMP, 150 ohms; HI IMP, 33k; AUX. EQ and PA.
4.7k. All outputs terminated as follows: all high-level outputs. 47k; MIC,
HEADPHONES - 1 OV 360 ohms 4 ohms or more 150 ohms; SPEAKER, 4 ohms: HEADPHONES, 200 ohms. |