Changing the Battery
When the indicator goes dim or no longer 1.Loosen the thumbscrew at the front of
lights while an effect is on, it means that the the pedal, then lift the pedal upwards to
battery is nearly dead and must be replaced. open the unit.
Replace the battery following the steps below.* The thumbscrew can be left in the pedal while
changing the battery.
*The use of an AC adaptor is recommended as the
unitOs power consumption is relatively high. Should 2. Remove the old battery from the battery
you prefer to use batteries, please use the alkaline type.housing, and remove the snap cord con-
fig.12
nected to it.
ThumbscrewPedal
3. Connect the snap cord to the new battery,
and place the battery inside the battery Spring Base
housing.
Battery Snap
Cord* Be sure to carefully observe the batteryOs
Coil Springpolarity (+ versus �).
4. Slip the coil spring onto the spring base
Guide Bush
Holeon the back of the pedal, then close the
pedal.
Battery* Carefully avoid getting the snap cord caught in the
Snappedal, coil spring and battery housing.
Battery Housing
5. Finally, insert the thumbscrew into the
9V Battery
guide bush hole and fasten it securely.
16 |