CHAPTER 3 MECHANICAL SYSTEM
6) Push in s test strip prepared in step [1]
K. Positioning the Paper
between the delivery roller and the pick-
Deflecting Solenoid (SL3)
up roller while pushing the plunger of the
paper retaining solenoid fully. Check to
1) Remove the body cover.
make sure that the delivery roller rotates
2) Loosen the fixing screw [1], and tighten it
when the rear and the front pick-up roller
when the stroke of the solenoid [2] is 4.5
is tested this way.
mm.
Test sheet
[1]
4.5mm
[2]
Figure 3-352Figure 3-353
Reference:
L. Stamp Solenoid
When pulling the test strip, the one-way
clutch will operate to hold the delivery
1) Remove the delivery roller unit (top pick-
roller from rotating.
up mode).
2) Remove the screw [1] and spring [2];
then, detach the flapper plate [3].
7) If the delivery roll does not rotate when a
test strip is pushed in, go back to step 3).
8) Shift the bits of the DIP switch (DSW1)
on the DADF controller PCB back to[2]
initial configuration.
[1]
[3]
Figure 3-354
3-26COPYRIGHT ? 1999 CANON INC. CANON DADF-C1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON) |
ACEC
CANON
