42010bGB.FM5 Page 58 Thursday, September 7, 2000 9:29 AM
INSTALLATION
Unpack the appliance and ensure that thDISCONNECTING THEe APPLIANCE
various elements (plastic bags, polystyrene Electrical disconnection must be possible
pieces, etc.) are well out of the reach of children.either by unplugging the appliance or by
Remove the 4 protection pieces inserted means of a double-pole switch located upline
between lid and appliance (A).from the socket.
Warning: two of the four protection pieces
(A) used to protect the door during transport
must be positioned into the seating in the
plastic condenser supports. This is located
on the rear panel of the appliance (E).
This measure is necessary to ensure the correAct
distance between applicance and panel.
Remove the packaging from the bottom
(B) of the freezer.
After connecting the appliance to the mains,
when the right temperature has been C
reached (about an hour), ensure that the fast
freeze function is inactive (yellow LED is off).B
During the freezing phase, the lid does
not open until the right temperature has
been reached (about 1 hour).
Ensure that the defrosting water drainage
plug is correctly positioned (C).
Ensure that the lid seal is not damaged: to
remove any deformation, warm the seal with
a hair dryer.
Before connecting the appliance to the mains
supply, ensure that the voltage corresponds to
that given on the rating plate (see figure below).
After the freezer has been installed, check
that it is not resting on the mains cable. 70 mm
Install the appliance in a dry, well ventilated
room. Avoid locations near a source of heat
or in direct sunlight.70 mm
70 mm
For best operation of the appliance and in
order to avoid damage when the lid is
opened, leave a space of at least 7 cm from
the rear wall and 7 cm at the sides.
Fit the accessories.
ELECTRICAL CONNECTION
Electrical connections must be made in
accordance with local regulations.
Data regarding voltage and absorbed power
are given on the rating plate on the rear of the
appliance(D) .
Regulations require that the appliance is
earthed. The manufacturer declines all
liability for injury to persons or animals and
damage to property resulting from failure to
observe the above prescriptions.
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
Do not use extension leads or adapters.
58 |
ACEC
IGNIS
