Installation
Materials Needed:6. Pull on tubing to confirm
1connection is secure. Connect
Y�4�outer diameter flexible copper tubing
1tubing to frame with water
Y Shut-off valve (requires a �4�hole to be drilled intoC
tubing clamp (C). Slide
water supply line beforevalve attachment)
waterline into retainer, then turn
Y Adjustable wrenches (2)
1on water supply. Check for
Y�4�hex nut driver
leaks and correct if necessary.
Waterline
Continue to observe the water
Notes:Retainer
supply connection for two to
Y Use only copper tubing for installation. Plastic is
three hours prior to moving the
less durable and can cause damage.refrigerator to its permanent location.
Y Add 8O to tubing length needed to reach water
7. Monitor water connection for 24 hours. Correct
supply for creation of service loop.leaks, if necessary.
1. Create service loop with copper
Opening and Closing Your
tubing (minimum 2O2O diameter
diameter). Avoid kinks inminimumFresh Food Doors
the copper tubing when2OYour new refrigerator is
bending it into a serviceVertical
uniquely designed with two
Hinged
loop. Do not use plastic
fresh food doors. Either doorSection
tubing.
can be opened or closed
independently of one another.
2. Remove plastic cap from water valve inlet port.
For proper usage and to
3. Place brass nut (A) and sleeve (B)avoid possible damage,
on copper tube end as illustrated.Aalwaysensure the vertical
Reminder: Do not use an oldhinged section (on the left
sleeve. The nut and sleeve arefresh food door) remains
B
provided in the Use and Care packet.folded inward beforeclosing
both doors. When both doors
are closed, the hinged section
automatically forms a seal between the two doors.
4. Place end of copper
tubing into water valveWhen the left door is opened, the vertical hinged
section automatically folds inward so that is is out of
inlet port.
the way.
5. Slide brass nut over
sleeve and screw nut intoWARNING
2
inlet port. Tighten nut
To avoid electrical shock which can cause severe
with wrench.
personal injury or death, DO NOT attempt to
1
remove the vertical hinged section from the fresh
(1) Place adjustable
food section.
wrench on nut attached
Waterline
to plastic waterline andSupply
RetainerCAUTION
maintain position.
To avoid possible product damage, ALWAYS verify
(2) Using second
that the vertical hinged section is folded against
adjustable wrench turn the upper nut clockwiseand
the edge of the door prior to closing.
fully tighten while holding the lower nut in place.
Important: Do not over-tighten. Cross threading may
occur.
9 |