Setting Up the Printer
DUse a coin to remove the twoGAttach the printer board cover
screws, and remove the cover.that was removed in step C, and
use a coin to fasten the six screws.
Note
r The removed screws are re-
1
quired in step F.
r The removed cover is no longer
required.
ZAEP014E
Note
r After installed the last option
that you want, print a configu-
ZAEP561E ration page to confirm the in-
stallation. If the new device is
EAlign the hard disk interface con-listed in the column of configu-
nector over the printer interfaceration options, then it has been
port, and push gently but firmlyproperly installed. For more in-
on the hard disk until it is com-formation on printing a config-
pletely connected.uration page, see P.37 ?Printing
a Configuration Page?.
ZAEP571E
FFasten the two screws that were
removed in step D to attach the
hard disk to the printer.
ZAEP581E
26 |