ifu_ajl308_eur_eng_37 19/9/07 15:09 Page 7
Safety and maintenanceTroubleshooting
Y No naked flame sources, such as lighted
Safety and general candles, should be placed on the apparatus.If a fault occurs,first check the points listed below before taking the set for repair.
maintenance Y Do not cover the set.Adequate ventilationIf you are unable to remedy a problem by following these hints,consult your dealer or
Y If you do not intend to use the clock radioservice center.
for a long time, withdraw the power cordwith a minimum gap of 6 inches between theWARNING:Do not open the set as there is a risk of electric shock.Under no
ventilation holes and surrounding surfaces is
from the wall outlet.necessary to prevent heat build-up.circumstances should you try to repair the set yourself,as this will invalidate the
Y Place the set on a hard and flat surface sowarranty.
that the system does not tilt.Y The mechanical parts of the set contain
self-lubricating bearings and must not be
Y Where the MAINS plug or an appliance oiled or lubricated.No sound.The screen brightness keeps turning dark.
coupler is used as the disconnect device, the
disconnect device shall remain readily Y To clean the set, use a soft dry cloth. Do not�Volume not adjusted.� The set is in auto dim timing.
operable.use any cleaning agents containing alcohol,Y Adjust the VOLUME.YTo let the screen keep bright, turn off auto dim
ammonia, benzene or abrasives as these maytimer.
Y Install the unit near the AC outlet and whereharm the housing.Occasional crackling sound during FM
the AC power plug can be easily reached.Note:
Y The apparatus shall not be exposed to drip-broadcast.
When opening the folder of an external
ping or splashing�Weak signal.device or its file stored in, read time may
Y Do not expose the set, batteries, to humidity,Y Extend the pigtail antenna fully.exceed the normal time due to large
rain, sand or excessive heat caused by
The alarm does not function.folder or file.
heating equipment or direct sunlight.
Y No objects filled with liquids, such as vases,� Alarm time is not set.
shall be placed on the appartus.Y See section on Setting and activating alarm.
� Alarm is not activated.
Y See section on Setting and activating alarm.
ONo card is selected� is displayed on the
screen.
�A USB device or memory card (SD or MMC) is
not inserted.
Y Insert a USB device or memory card (SD or
MMC). |
ACEC
PHILIPS
