INSTALLATION
Technical information for the installer
OVEN
? After removing the oven from its packaging, before
making the connections place it on the polystyrene
foam base to protect it from damage.
Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure (see arrow).
Check that the appliance has not been damaged in
transit.
Oven dimensions and kitchen unit dimensions are
shown in the figure opposite.
Kitchen units in contact with the oven must be heat
resistant (80° C).
If plastic laminates or cement are not sufficiently
heat-resistant, warping, bubbling or detachment of
the finish may result.
Install the oven in the housing, lifting it at the sides,
taking care not to trap the wires of the electrical
supply cable.
For correct ventilation, follow the ventilation
opening directions shown in the figure No Contacts
(500 x 80 mm min). An additional opening of 5 mm
is required between the oven top rim and the
cooktop lower rim: this opening must not be closed
by strips or housing crosspieces.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
Carry out the electrical connections between
cooktop and oven (see ?Electrical Connection?).
Secure the oven to the kitchen unit with screws (A)
as shown.
100 |
ACEC
WHIRLPOOL
