How to proceed if ...
? Open the door.
? Pull the filter upwards.
Clean the filter at the end ? Open the filter.
? Brush lint using a soft brush or your
of every cycle.fingertips.
? Close the filter.
? Push the filter back into place.
? Pull the handle to remove the water
container.
...you want to correctly Empty the water container ? Empty the water container.
care for and clean your at the end of each drying ? Replace the water container when empty
dryer:cycle.by pushing it completely back in place.
? Remove fibres in and around the water
evacuation hole at least once per month.
Clean the heat exchanger
at least every month.
(For further information
see chapter ?Heat
Exchanger? in the
Instructions for Use).
? Has the correct drying programme been
selected?
? Was the inserted laundry too wet
(washing machine spin speed less than
800rpm?
Drying takes too long / ? Is the lint filter dirty (filter indicator light on)?
laundry is not dry enough? Is the heat exchanger dirty? (for more
information, refer to the instructions for use)
? Is the room temperature too high?
? Are the END and Anti-crease indicator
lamps lighting up? The drying cycle is
complete and the laundry can be taken out.
...you want to check the ? Is the plug properly inserted into the
dryer yourself first:mains electricity socket?
The dryer will not operate ? Is there a power failure?
(If your machine is not
(after a power failure, ? Has the fuse blown?
functioning correctly, please
check the following points always press the ? Is the door properly closed?
before phoning for the Départ / Pause button).? Has a drying programme been selected?
? Has the Départ/Pause button been
customer service - also refer
to relevant chapter in the pressed?
? Is the lint filter clean?
instructions for use)Lint filter or water ? Is the water container empty?
container indicator ? Has the water container been inserted
lamp on.correctly?
? Is the heat exchanger clean?
? Has the heat exchanger been inserted
correctly?
? Has any fluff on the heat exchanger seal
Water droplets underneath been wiped away?
the dryer.? Has any fluff on the door seal been
wiped away?
? Has the water container been inserted
correctly?
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the
machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
? the nature of the fault.
? the dryer type and model
? the service code (the number after the word Service on the adhesive
rating plate) on the right-hand side when the door is open.
3 |
ACEC
LADEN
