Samson AirLineQuickStart
If youve had some prior experience using wireless systems, these QuickStart instructions will get you up and running with your AirLine
UHF guitar system in a matter of minutes! Detailed instructions for setting up and using your AirLine system can be found on page 12 of
this manual, and the Guided Tour sections on pages 4 - 11 provide full descriptions of all AirLine component controls and displays.
1. Make sure that the supplied AP1 receiver and AF1 or AG1 transmitter are factory preset to the same channel.
ENGLISH
2. Physically place the AP1 receiver on the ground in front of you. Extend its antennas vertically and spread the tips horizontally outwards
approximately 5 inches.
3. Set the power switch on your AF1 or AG1 transmitter to the off position (away from the arrow) and place a fresh AAA battery in it. Then
turn the transmitter back on momentarily; its LED will flash once and then go off if the battery is sufficiently strong. Once battery strength is
verified, turn the transmitter off again, then plug it into your electric guitar or bass.
4. Open the battery compartment of the AP1 by pressing on the latch and install a fresh battery; if you prefer, you can use an optional
power supply instead. Turn the AP1 on momentarily to confirm that the battery has been installed correctly (or that the adapter has been
connected correctly); the On/Battery Low LED should light green and not red. Then turn the AP1 power off.
5. Turn your amplifier or mixer off and make the physical cable connection between an audio input and the AP1 output jack.
6. Turn the Level knob on the AP1 completely counterclockwise, then turn its power on; the Power LED will light steadily green.
7. Turn on your AF1 or AG1 transmitter. The TX/Peak LED on the AP1 receiver should light steadily green, indicating that it is receiving
valid RF signal and is placed and positioned correctly.
2 |
ACEC
SAMSON
