8. Loading copy paper9. Power to copier
Note: This copier is equipped with two paper trays. Load copy paper1) Ensure that the power switch of the copier is in the OFF position.
into the two paper trays.Insert the attached power cord into the power cord socket at the
1) Raise the handle of the paper tray and pull the paper tray out untilrear of the copier.
it stops.2) Plug the other end of the power cord into the nearest outlet.
10. Moving
Moving instructions
When moving the unit, follow the procedure below.
Note: When moving this unit, be sure to remove the TD cartridge in
2) Remove the pressure plate lock. Rotate the pressure plate lock inadvance.
the direction of the arrow to remove it while pressing down the1) Turn the power switch off and remove the power cord from the out-
pressure plate of the paper tray.let.
2) Open the side cover and front cover, in that order. Remove the TD
3) Store the pressure plate lock that was removed in step 2 and thecartridge and close the front cover and side cover, in that order.
screw that was removed when unpacking the machine in the frontTo open and close the side cover and front cover, and to remove
of the paper tray. To store the pressure plate lock, rotate the lockthe TD cartridge, see "TD CARTRIDGE REPLACEMENT".
to fix it on the relevant location.
4) Adjust the paper guides on the paper tray to the copy paper width3) Raise the handle of the paper tray and pull the paper tray out until it
and length.stops.
Squeeze the lever of paper guide (A) and slide the guide to match4) Push the center of the pressure plate down until it locks in place
with the width of the paper.and lock the plate using the pressure plate lock which has been
Move paper guide (B) to the appropriate slot as marked on thestored in the front of the paper tray.
tray.5) Push the paper tray back into the unit.
6) Lock the scan head locking switch.
Note: When shipping the unit, the scan head locking switch must be
locked to prevent shipping damage.
7) Close the multi-bypass tray and the paper output tray extension,
and attach the packing materials and tape which were removed
during installation of the unit. See "PREPARING THE UNIT FOR
Paper INSTALLATION".Paper
guide (B)guide (A)8) Pack the unit into the carton. See "CHECKING PACKED COMPO-
NENTS AND ACCESSORIES".
5) Fan the copy paper and insert it into the tray. Make sure the edges
go under the corner hooks.
Note: Do not load paper above the maximum height line ().
Exceeding the line will cause a paper misfeed.
6) Gently push the paper tray back into the copier.
Note: After loading copy paper, to cancel the blinking "H" without
restarting copying, press the clear () key. The "P" in the
display will go out and the ready () indicator will light up.
AR-122E/152E/153E/157E UNPACKING AND INSTALLATION 5 - 4 |
ACEC
SHARP
