USER PROGRAMS
Setting the user programs
Press and hold the light () key for more than 5
1seconds until all the alarm indicators (, , , ,
and ) blink and ?- -? appears in the copy quantity
display.
Enter a program number using the numeric keys.
l
2The selected program number will blink in the copy quantity display.
lIf a mistake is made in steps 2 to 4, press the CLEAR () key. The
copier will return to step 2.
lThe program numbers are shown in the table below.
For example, to change the setting of the auto power shut-off timer,
press key 3.
Program nameProgram No.
Auto clear time1
Preheat mode2
Auto power shut-off timer3
Stream feeding mode4
Auto power shut-off setting5
Border line for 2 in 1 or 4 in 16
Rotation copy7
Auto paper select mode8
Auto tray switching9
Auditing mode10
Account number entry11
GENERAL INFORMATIONFor operation of these programs afterAccount number change12
step 3, see page 54.Account number deletion13
Number of copies per account14
Resetting account15
Erase width adjustment16
Layout in 2 in 1 copy17
Layout in 4 in 1 copy18
Offset of paper output tray19
Image rotation in duplex copying20
Location of the margin22
User programs
Press the START key.
3lFor programs 1 to 9 and 16 to 22, the entered program number will be
steadily lit on the left side of the copy quantity display and the
currently selected parameter number for the program will blink on the
right side.
lFor programs 10 to 15 (programs for auditing accounts), the display
varies with the program number. See page 54 for setting programs 10
to 15.
52 |
ACEC
SHARP
