AV32T25EKS / AV32R25EKS
AV32T55EKS / AV32R250EKS
AV32T25EIS
REMOVING THE CRT
Replacement of the CRT should be performed by 2 or more
persons.CRT CHANGE TABLE
" After removing the cover, chassis etc.,
1. Putting the CRT change table on soft cloth, the CRT change table
should also be covered with such soft cloth (shown in Fig.8).
APPROX.
2. While keeping the surface of CRT down, mount the TV set on the35cm
CRT change table balanced will as shown in Fig.9.
3. Remove 4 screws marked by arrows with a box type screw driver
CLOTH
as shown in Fig.9.
" Since the cabinet will drop when screws have been removed, be
sure to support the cabinet with hands.
4. After 4 screws have been removed, put the cabinet slowly on
cloth (At this time, be carefully so as not to damage the frontFig. 8
surface of the cabinet) shown in Fig.10.
" The CRT should be assembled according to the opposite
sequence of its dismounting steps.CRT
The CRT change table should preferably be smaller that the CRT
surface, and its height be about 35cm.
CRT
CHANGE
TABLE
BOX
TYPE
SCREW
DRIVER
Fig. 9
CRT
CABINET
CRT
CHANGE TABLE
Fig. 10
CAUTION (Only AV32R25EKS / AV32R250EKS)
" The woofer unit is mounted on the TV. Always move the TV and woofer unit together when removing the TV from the box, or when
moving the woofer unit.
" If the TV is tilted during movement the woofer unit may fall. Be careful to keep the TV level when moving it.
" Do not grip the woofer unit when moving the TV.
" Do not place objects on the woofer unit duct.
10No. 51968 |
ACEC
JVC
