CONSUMPTION DATAPROGRAMME CHANGENOTES AND INDICATIONS FOR USE
TemperatureLoadWaterEnergyApprox. ProgrammeTo reselect a programme when a cycle has already ? WATER LEVEL
SelectorDurationbegun: It may not be visible as the cycle is optimised
Programme
1. Switch off the appliance by pressing the On/Off? for a minimum water consumption without
(C)(kg)(l)(kWh)(hours : minutes) button. compromising washing results.
2. Select the new programme.
Cotton954,549*1,702:05? SPIN SPEED CONTROL
3. Start the programme by pressing the On/Off? Spin speed may be reduced automatically or may
Cotton605,0460,952:20 button. even be excluded in the case of small loads with
Cotton404,5440,602:05 highly absorbent garments (e.g. bathrobes, bathmat).
END OF WASH CYCLE This control avoids cloth and machine damage and
Synthetics602,0550,801:30 excessive vibrations and consequent noise produced
1. At the end of the programme the programme
Synthetics402,0550,601:20 by the machine due to load unbalance: by selecting
selector moves to the stop position. high spin speeds the noise level increases.
Delicates301,5600,500:452. To unload the machine wait for the door to unlock
? MOTOR NOISE
Wool301,0600,300:40 (about 1 minute). The running noises of the new, electronically-
3. Switch off the appliance, open the door and take out
controlled motor are not the same as the ones you
Silk301,0600,300:50 the laundry.
are used to from your old appliance. Don't be
4. Close the tap and leave the door ajar to allow the
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in surprised - modern technology has a modern sound.
drum to dry out.
compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to
? CLEANING THE FILTER
the water supply pressure and temperature, the load and the type of wash. To ensure an impeccable function of the pump,
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water
check the filter regularly and clean it if necessary.
out.
ADD DETERGENTS, CLOSE THE DOOR AND SELECT ANY DESIRED OPTION
SELECT THE PROGRAMME
Half Load button
Add the detergents as described in the programme table ? Reduces water consumption, above all during
or in the chapter Detergents and Additives in the rinsing.
booklet.? Suitable for lightly-soiled laundry and small loads
1. Open the tap. (max 3 kg).
2. Set the programme selector to the desiredNote: Reduce the detergent quantity.
programme.No Spin button
3. Turn the temperature selector to the desired? Especially for delicate garments to avoid wear and
temperature. tear caused by the spin.
4. Special options can be selected.Note: with the Cotton and Synthetics programmes
5. Check that the door is well closed and turn on the a short spin cycle is provided in any case, even
washing machine by pressing the On/Off button. if the exclusion has been selected, in order to
The indicator lights up, indicating that the washing optimize rinsing results.
machine is on.
Whirlpool is a registered trademark of Whirlpool USA.
5019 301 10202 |
ACEC
WHIRLPOOL
