30110447GB.fm Page 6 Thursday, May 10, 2007 12:35 PM
Where to put detergent and additivesSeparator
A
The detergent drawer has three chambers (fig. ?A?).
Prewash Chamber
Detergent for the prewash
Main Wash Chamber
Detergent for the main wash
Stain remover
Water softener
()
Softener Chamber
Fabric softener
Liquid starch
Pour additives only up to the ?MAX? mark.
A
Using chlorine bleachHooks
Separator
Wash your laundry in the desired programme (Cotton, Synthetics),
adding an appropriate amount of chlorine bleach to the SOFTENER
}
chamber (close the detergent dispenser carefully).
Immediately after end of programme, start the ?Rinse and Spin?
programme to eliminate any residual bleach smell; if you want,
Guide
you can add softener.
Rails
Never put both chlorine bleach and softener into the softener B
chamber at the same time.
2
Using starch
Select the ?Rinse and Spin? programme and check that the spin 3
speed is adjusted to not more than 800 rpm.
1
Start the programme, pull out the detergent dispenser so that you
can see approximately 3 cm of the softener chamber.
Pour the starch solution prepared into the softener chamber
while the water is running into the detergent dispenser.
How to position the separator in the main wash
C
chamber for powder or liquid detergent
For use with powder detergent: place the separator in the higher
position.
Lift the separator until its top can be reclined. Place its hooks on the
upper end of the back guide rails and slightly push the separator
down to fix it (fig. ?B? and ?C?).
A gap should remain between the separator and the bottom of the main
wash chamber, if the separator has been correctly installed (fig. ?B? and
?C?).
For use with liquid detergent: place the separator in the lower position.
Secure the separator in the chamber using the front guide rails.
D
Position the separator so that it touches the bottom of the main
wash chamber (fig. ?D?).
GB 6
Black process 45.0° 100.0 LPI |
ACEC
WHIRLPOOL
