INSTALLATION INSTRUCTIONS
DRAINING
(varies according to model)
Fig. 1
a) Drain hose on rear panel of appliance,
Figure 1
1. Unhook the drain hose from the left clip, see
arrow A in Fig. 1.
Important:
Do NOT loosen the right drain hose
connection, see arrow B in Fig. 1, otherwise
there is the risk of leakage (danger of
scalding with hot water).
b) Appliance internal drain hose, Figure 2
1. Pull the hose completely out of the holder
(see Figure 2, 1).
2. Close off the hole with the attached cap
(see Figure 2, 2).1
? Drain hose connection to water outlet.
1. Either fit the drain hose to the stand pipe
drain or fit the supplied ?U? bend, if not
already installed, and hook it over the edge of
a sink or bath tub (see Figure 2, 3). Small
hand basins are not suitable. The edge of the
tub must be no higher than 125 cm above the
floor.
2. Minimum drain height: 70 cm.
Maximum drain height (?U? bend): 125 cm.
3. If you need to add an extension, use a Fig. 2
flexible hose of the same type and secure the
union with screw-on hose clips. 2
Maximum overall drain hose length 2.5 m.
Important
Make sure that there are no kinks in the drain hose
run and take precautions against it falling while the 3
appliance is running (Fig. 3).
CONNECTION TO THE MAINS
? Observe local utility company regulations.
? The connection must be made with a correctly
installed, earthed and insulated socket.
? The system must be earthed.
The manufacturer declines all responsibility
for injury to persons or pets and damage to
property caused by disregarding the above
instructions.Min 70 cm
? The data concerning voltage, consumption Max 125 cm
and necessary fuse are supplied on the
inside of the appliance door.
? The mains connection cable may only be
replaced by a qualified electrician.
? The appliance conforms to European safety
regulations, EC directive 93/68/EEC and
EN 60555.
? Do not use extension leads or multiplugs.
Fig. 3
40 |
ACEC
IGNIS
