AZ 1007/14 page 11
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
EnglishWARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEM
� POSSIBLE CAUSE
Y REMEDY
No sound/powerThe CD skips tracks
� VOLUME is not adjusted� CD is damaged or dirty
Y Adjust the VOLUMEY Replace or clean the CD
� Headphones are connected� SHUFFLE or PROGRAM is active
Y Disconnect headphonesY Quit SHUFFLE/PROGRAM mode(s)
� Mains lead not securely connectedPoor cassette sound quality
Y Connect the AC mains lead properly� Dust and dirt on the heads, etc.
� Batteries exhaustedY Clean deck parts etc., see Maintenance
Y Insert fresh batteries� Use of incompatible cassette types (METAL
� Batteries incorrectly insertedor CHROME)
Y Insert the batteries correctlyY Only use NORMAL (IEC I) for recording
Display does not function properlyRecording does not work
� Electrostatic discharge� Cassette tab(s) may be broken out
Y Switch off set, disconnect the mains plug andY Apply a piece of adhesive tape over the
reconnect after a few secondsmissing tab space
CD playback does not work
� CD is badly scratched or dirty
Y Replace or clean the CD, see Maintenance
� Laser lens steamed up
Y Wait until lens has acclimatized
Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the
packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene
(buffer), polyethylene (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
The type plate is located on the bottom of the set.
11 |
ACEC
PHILIPS
