XP AZ 1008/17 23-10-2000 14:31 Pagina 15
Troubleshooting
If a fault occurs,Å¢rst check the points listed below
before taking the set for repair.Do not open the
set as there is a risk of electric shock.
If you are unable to remedy a problem by followingEnglish
these hints,consult your dealer or service center.
WARNING:Under no circumstances should you try
to repair the set yourself,as this will invalidate the
warranty.
ProblemSolution
No sound � Adjust the VOLUME
Power cord not securely � Connect AC power cord properly
connected
Batteries dead /incorrectly � Insert (fresh) batteries correctly
inserted
Display does not function � Electrostatic discharge
properly/ No reaction to � Switch off and unplug the set. Reconnect after a few
operation of any of the seconds.
controls
Er indication� No CD inserted, insert a CD
CD badly scratched or dirty� Replace/ clean CD, see Maintenance
Laser lens steamed up� Wait until lens has cleared
� Wait until lens has acclimatized
CD-(R) is blank or the disc � Use a Ţnalized CD-(R)
is not Ţnalized
CD playback does not work� CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
The CD skips tracks� CD damaged or dirty. Replace or clean CD.
� Program is active. Quit program mode
Poor cassette sound quality� Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
� Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
Recording does not work� Cassette tab(s) may be broken.Apply a piece of
adhesive tape over the missing tab space.
15 |
ACEC
PHILIPS
