Maintenance & Safety (See 7)Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
CD player and CD handling Safety information
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Y If the CD player cannot read CDs correctly,Y Place the set on a flat, hard and stable surface
WARNING:Do not open the set as there is a risk of electric shock.Under no
use a cleaning CD to clean the lens beforeso that the system does not tilt.
circumstances should you try to repair the set yourself,as this will
taking the set to repair.Y Do not expose the set, batteries, CDs to
invalidate the guarantee.
Y The lens of the CD player should never behumidity, rain, sand or excessive heat caused
touched!by heating equipment or direct sunlight.
Problem -- indication
Y Sudden changes in the surrounding Y The apparatus shall not be exposed to drip-
temperature can cause condensation on theping or splashing.� Possible cause
� No CD inserted
lens of your CD player. Playing a CD is thenY Remedy
Y Adequate ventilation with a minimum gap ofY Insert a CD
not possible. Do not attempt to clean the
15cm (6 inches) between the ventilationNo hay sonido/energ?a � CD badly scratched or dirty
lens but leave the set in a warm environmentholes and surrounding surfaces is necessary
� Volume not adjustedY Replace/ clean CD, see Maintenance
until the moisture evaporates.to prevent heat build-up.
Y Adjust the VOLUME � Laser lens steamed up
YAlways close the CD-tape door to avoid dust
Y Do not cover the ventilation openings with
� Power cord not securely connectedYWait until lens has cleared
on the lens.items such as newspapers, table-cloths, cur-
Y Connect the AC power cord properly� CD-R/CD-RW is blank or not finalized
YTo clean the CD, wipe in a straight line fromtains, etc.
� Batteries dead/ incorrectly insertedY Use a finalized CD-R/CD-RW or suitable CD
the center towards the edge using a soft,
Y No objects filled with liquids, such as vases,
Y Insert (fresh) batteries correctlyAudio disc only
lint-free cloth. Do not use cleaning agents as
shall be placed on the apparatus.
� Headphones connected to the set
they may damage the disc.Note:
Y No naked flame sources, such as lighted can-Y Disconnect headphones.
Y Never write on a CD or attach any stickersMake sure the CD is not encoded with
dles, should be placed on the apparatus.
� CD contains non-audio filesCopyright protection technologies,as some
to it.
Y The mechanical parts of the set contain Y Press , § once or more to skip to a CD audiodo not conform to the Compact Disc stan-
self-lubricating bearings and must not be oiledtrack, instead of the data file.dard.
or lubricated.
YTo clean the set, use a dry cloth. Do not useThe CD skips tracks
any cleaning agents containing alcohol,Display does not function properly / No
ammonia, benzene or abrasives as these mayreaction to operation of any of the � CD damaged or dirty
harm the housing.controls Y Replace or clean CD
� Program/Shuffleis active
� Electrostatic discharge
Y Quit program/shuffle mode
Y Switch off and unplug the set. Reconnect after a
few secondsNote:A CD badly scratch or dirty may result in
improper operation.
Severe radio hum or noise
� Electrical interference:set too close to TV,VCR or
computer
Y Increase the distance
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated
Poor radio reception
into three materials: cardboard, polystyrene and plastic.
� Weak radio signal
Your set consists of materials which can be recycled if disassembled by a
Y FM:Adjust the FM telescopic aerial
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment. |
ACEC
PHILIPS
