CASSETTE RECORDERMAINTENANCE & SAFETY
CD Synchro Start recordingY No naked flame sources, such as lighted candles,
CASSETTE RECORDERMaintenance & Safety (See 8, 9)
Cassette playback1 Select CD/MP3 function.CD player and CD handling should be placed on the apparatus.
2 Insert a CD and if desired, programme track num-Y The mechanical parts of the set contain
1 Push the source selector to TAPE..bers.Y If the CD player cannot read CDs correctly, use a
2 Insert a cassette and close the door.cleaning CD to clean the lens before taking the setself-lubricating bearings and must not be oiled or
3 Press PLAY 1 to start playback.3 Open the cassette door.to repair.lubricated.
4 Insert a suitable tape into the cassette deck and
Display: shows TAPE throughout tape opera-close the door.Y The lens of the CD player should never be touched!YTo clean the set, use a dry cloth. Do not use any
tion.Y Sudden changes in the surrounding temperaturecleaning agents containing alcohol,
5 Press RECORD 0 to start recording.
4 To pause, press PAUSE ;. Press again to resume.? Playing of the CD/program starts automaticallycan cause condensation on the lens of your CDammonia, benzene or abrasives as these may
5 To stop the tape, press STOP/OPEN 9/.player. Playing a CD is then not possible. Do notharm the housing.
from the beginning. You donOt need to start theattempt to clean the lens but leave the set in a
Fast forwarding/rewindingCD player separately.Tape deck maintenance
? Display: shows briefly.warm environment until the moisture evaporates.
1 Press SEARCH 5 or 6 until you reach yourY Always close the CD door to avoid dust on theTo ensure quality recording and playback of the tape
desired passage.6 To pause recording, press PAUSE ;. deck, clean parts A, B and C as shown, once a
Press PAUSE ; again to resume recording.lens.month. Use a cotton bud slightly moistened with alco-
2 Press 9/ to stop fast forwarding/rewinding.YTo clean the CD, wipe in a straight line from the
7 To stop recording, press STOP/OPEN 9/.centre towards the edge using a soft, lint-freehol or a special head cleaning fluid to clean the deck.
Helpful hints:1 Open the cassette door.
� During playback, the keys are automaticallyRecording from the Radiocloth. Do not use cleaning agents as they may2 Press PLAY 1 and clean the roller C.
1 Tune to the desired radio station (see Tuning todamage the disc.
release at the end of a tape, and the set isY Never write on a CD or attach any stickers to it.3 Press PAUSE ; and clean the heads A, and the
switched off (except if ; has been activated).radio stations).capstan B.
2 Follow steps 3-7, under CD Synchro Start record-
� During fast winding/rewinding, the keys will notSafety Information4 After cleaning, press STOP/OPEN 9/.
be released at the end of a tape. To switch offing.
Y Place the set on a hard, flat and stable surface so
the set, make sure the cassette keys are alsothat the system does not tilt.
released.
Y Do not expose the set, batteries, CDs to humidity,
GENERAL INFORMATION ON RECORDINGrain, sand or excessive heat caused by heating
Y Recording is permissible insofar as copyright or.equipment or direct sunlight.
other rights of third parties are not infringed.Y The apparatus shall not be exposed to
Y For recording, use only NORMAL type cassettesdripping or splashing.
(IEC type I) on which the tabs have not yet been
Y Adequate ventilation with a minimum gap of 15
broken. This deck is not suited for recording oncm between the ventilation holes and surrounding
CHROME (IEC II) or METAL (IEC IV) type cassettes.
Y The best recording level is set automatically.surfaces is necessary to prevent heat build-up.
Y The ventilation should not be impeded by cover-
Altering the VOL or DBB controls will not affect
the recording.ing the ventilation openings with items, such as
YTo protect a tape from accidental erasure, breaknewspapers, table-cloths, curtains, etc..
out the tabs. If you wish to record again, cover theY No objects filled with liquids, such as vases, shall
tabs with a piece of adhesive tape.be placed on the apparatus.
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3 materi-
als:cardboard, expandable polystyrene, polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packaging, exhausted batteries
and old equipment. |
ACEC
PHILIPS
