AZ 2025 /00 page 14
TROUBLESHOOTING
EnglishIf a fault occurs, first check the points listed below before taking the set for repair. If you are unable
to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
PROBLEM
� POSSIBLE CAUSEindication
Y REMEDY� CD-R(W) is blank or the disc is not finalised
No sound/power
Y Use a finalised CD-R(W)
� VOLUME not adjusted� CD badly scratched or dirty
Y Adjust the VOLUMEY Replace/ clean CD, see Maintenance
� Headphones connected
Y Disconnect headphones
The CD skips tracks
� Mains lead not securely connected� CD is damaged or dirty
Y Connect the AC mains lead properlyY Replace or clean the CD
� Batteries exhausted/ incorrectly inserted� SHUFFLE or PROGRAM is active
Y Insert (fresh) batteries correctlyY Switch off SHUFFLE / PROGRAM
Severe radio hum or noisePoor cassette sound quality
� Electrical interference: set too close to TV,� Dust and dirt on the heads, etc.
VCR or computerY Clean deck parts etc., see maintenance
Y Increase the distance� Use of incompatible cassette types (METAL
or CHROME).
Poor radio receptionY Only use NORMAL (IEC I) for recording.
� Weak radio signal
Y FM: Direct the FM telescopic aerial forRecording does not work
� Cassette tab(s) may be broken
optimum receptionY Apply a piece of adhesive tape over the
Y MW/LW: Turn the set for optimum reception
missing tab space.
Remote control does not function properly
indication� Batteries exhausted/ incorrectly inserted
Y Insert (fresh) batteries correctly
� No CD inserted
Y Insert a CD� Distance/ angle between the set too large
� CD badly scratched or dirtyY Reduce the distance/ angle
Y Replace/ clean CD, see Maintenance
� Laser lens steamed up,
Y Wait until lens has cleared
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
14 |