3 - 8
INSTRUCTIONS FOR USE
TV or VCR.
Insert a disc.Check if the disc is inserted upside down.Wait until the moisture condensation at the lens has cleared.Replace or clean the disc, see "Maintenance"Use a readable disc or correct recorded format MP3-CD.Connect the cable between the system and TV.Change the system to the respective PAL or NTSC setting.If the signal is too weak, adjust the antenna for better reception.Increase the distance between the Receiver and your Clean deck parts, see "Maintenance".Use only NORMAL (IEC I) tape. Apply a piece of adhesive tape over the missing tab space.Slide the source sector to TAPE/OFF. Remove andAdjust the volume.Make sure the MP3-CD was recorded within 32-320 kbps (128kbps preferably) with sampling frequencies at 8 - 48 kHz (44.1kHz preferably).Reduce the distance between the remote controlInsert the batteries with their polarities (+/- signs) aligned as indicated.Replace the batteries.Point the remote control in the direction of the system's IR sensor.
-------------------
Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
" is displayed
ARNING:
TROUBLESHOOTINGIf a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre.WProblemSolutionCD/VCD OPERATION "NO DISCNo picture on TV screenNo colour on TVRADIO RECEPTION Radio reception is poorTAPE OPERATION/RECORDING Recording or playback cannot be madeGENERAL The system does not react when buttonspressed/set does not work/no display onreconnect the AC power plug for 30 seconds and LCD.switch on the system again. Sound cannot be heard or is of poorqualityThe remote control does not functionproperlyand the system.
English
English
C
B
E
NEPOOTTFILGTUNINPLAYEARCHVOLUMEPEATIROGRAPCBASMSBOORDYNAMSTBBDA
EARCHSSTOPCHSTOPOPENUSESPASEAR
SOUND130MACHINE
DMP3CDVC5AZAUSEAY/PPL
LIFTTOOPENFFMWFMTAPECD-VCDO
A
X
MAINTENANCE
cassette through once.
.
.
9/C
.and also the
A
.
STOPOPEN
9/
never be touched
STOPOPEN
show in the diagram below, after approx. 50 hours ofand clean the magnetic heads
Cand clean the rubber pressure rollers ;
on a CD or attach stickers to it.1.
andB
AUSE
,BPLAY P
A
Place the set on a hard, flat surface so that the system does not tilt.Always shut the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth.The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated.o clean the set, use a soft, slightly dampened chamois leather. Do notuse any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.The lens of the CD player should Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.Use only Digital Audio CDs.o take a CD out of its box, press the centre spindle while lifting theCD. Always pick up the CD by the edge and replace the CD back in its box after use to avoid scratching and dust.o clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc.Never writeAPE DECK MAINTENANCEensure a good recording and playback of the tape deck, cleanOpen the cassette holder by pressing ressresscapstansfter cleaning, press
PRECAUTIONS & GENERAL MAINTENANCECD PLAYER AND CD HANDLINGT
TTTTopartsoperation, or on average once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. PPACleaning of the heads can also be done by playing a cleaning |
ACEC
PHILIPS
