TM
Chiller Fresh control(A) is located below front shelf trim.
Storage Rack (some models)
Control adjusts amount of air circulating around drawer.
Storage rack(A) provides convenient storage for a large
Slide control to COLD for normal refrigerator temperature
and to COLDER for colder temperature. Ice crystals maybottle, eggs, etc.
form on drawer or food on COLDER setting. Cold air
? Hang rack by hooking over side of shelf.
TM
entering the Chiller F drreshawer can decrease
refrigerator temperature. Fresh food control may need to
be adjusted to a lower number to compensate for colder
air.
TM
Chiller Fresh drawer can be moved from the left to the
right side of the refrigerator compartment to accomodate
different storage needs.
To install on left side, see Figure 1. To install on right
side, see Figure 2
1. Remove drawer(B) by lifting and pulling out. Remove
shelf(C) by lifting from front, releasing hooks from
metal track(D), then pulling out.
2. Remove plastic cap(E) from back wall of fresh food
section by placing a knife covered with masking tape
underneath cap and pulling forward.
A
3. Rotate boot(F) 180° to opposite side.
4. Insert plastic cap in hole(G) opposite side of fresh
food section. Confirm cap is snugly in place. Cold air
may cause food to freeze if cap is not replaced.
Covered Storage Bucket (some models)
5. Replace shelf by inserting hooks into metal track and
The covered storage bucket has a lid and removable egg
lowering the front. Use slots 4 though 6 only.
tray. When tray is removed, bucket will accept standard
6. Replace drawer by sliding in. Make sure boot fits
egg carton, ice, etc.
snugly over air inlet in back wall.
D
C
F G
1E
Dairy Center (some models)
The dairy center provides convenient storage for butter,
A
cheese, etc.
D
B? Remove dairy center by lifting door(A), pushing
tabs(B) of shelf down on both sides, and pulling out.
? Replace dairy center by sliding in until tabs lock
G
into place, then lower door.
EF
C
2
B
A
A
B
14 |
ACEC
WHIRLPOOL
