INSTALLATION INSTRUCTIONS
NotesReplacing the supply cable
? The appliance must be correctly installed To connect the cooker supply cable, proceed as
by a qualified technician in accordance follows (see Fig. 1):
with the applicable safety standards. Open the terminal board cover, which is
It is essential that this appliance is placed on the bottom right rear panel, making
earthed.pressure on the two tongues.
The manufacturer cannot accept any Remove about 60 mm of the external
liability for personal injury or damage to sheathing from the power supply cable. The
property resulting from a failure to earthing wire, which is coloured yellow and
comply with the above-mentioned green, must be 30 mm longer than the other
standards.power cable wires.
Remove the cardboard protections from Pass the power supply cable into conduit (C)
inside the oven. of the terminal board.
Fit the accessories. Connect it to the terminal strip in accordance
The sides of furniture or appliances located with the electrical diagram shown below.
next to the cooker must be capable of Ensure that the ?GREEN and YELLOW? wire
withstanding temperatures which can reach is connected to the earth terminal (marked by
80°C. the symbol ).
Electrical connection Fix the cable into the cable clamp, using
Before connecting the appliance, it is necessary screws L-N.
to ensure that: Fix the cable into conduit (C) and close the
1. The nominal voltage of the electrical power terminal board cover.
supply to the dwelling is the same as that of
Note: After the installation, the electrical parts
the appliance, as stated on the rating plate must not be accessible without the use of an
which is visible after removal of the drawer. appropriate tool. The power supply cable must
On cookers without drawer the rating plate is
placed on the rear side.be of the type H05RR-F, in accordance with the
table below.
2. The power supply line to which the appliance
is to be connected is of a sufficient power,
relative to the maximum power consumed by The supply cable must not come into contact
the appliance, as stated on the rating plate.with any component the temperature of which
3. The electrical power installation of the exceeds the ambient temperature by 50°C.
dwelling is correctly earthed.
POWER SUPPLY CONDUCTORSELECTRICAL
VOLTAGENUMBER X DIMENSIONSCONNECTION
1N ~ 230V3 x 0,75 mm2
LN
Fig. 1
22 |
ACEC
LADEN
