CP-S318(C3SM4) / CP-X328(C3XM4)
Related Messages
When the unit's power is ON, messages such as those shown below may be displayed. When
any such message is displayed on the screen, please respond as described below.
MessageDescription
CHANGE THE LAMPLamp usage time is approaching 2,000 hours. (Note 2)
AFTER REPLACING LAMP, Preparation of a new lamp, and an early lamp change, is
RESET THE LAMP TIMER.recommended. After you have changed the lamp, please be
(Note 1)sure to reset the lamp timer.
Lamp usage time is approaching 2,000 hours. A lamp change
CHANGE THE LAMP
AFTER REPLACING LAMP,withinhours is recommended. (Note 2)
When lamp usage reaches 2,000 hours, the power will
RESET THE LAMP TIMER.automatically be turned OFF. Please change the lamp by
THE POWER WILL TURN OFFreferring to THE LAMP in Vol.1 (Basic). After you have
AFTERhr.
changed the lamp, please be sure to reset the lamp
(Note 1)timer.
As lamp use has reached 2,000 hours, the power will soon be
CHANGE THE LAMPautomatically turned OFF. (Note 2)
AFTER REPLACING LAMP,Please immediately turn the power OFF, and follow the
RESET THE LAMP TIMER.instructions in the THE LAMP section of the separate booklet,
Vol.1 (Basic).
THE POWER WILL TURN OFF
AFTER 0 hr.After you have changed the lamp, please be sure to reset the
lamp timer.
CLEAN THE AIR FILTERA note of precaution when cleaning the air filter.
AFTER CLEANING AIR FILTER,After cleaning the filter, operate FILTER TIME of the OPTION
RESET THE FILTER TIMER.Menu, and perform reset of the filter timer.
There is no input signal.
NO INPUT IS DETECTEDPlease confirm the signal input connection, and the status of the
ON
signal source.
The horizontal or vertical wavelength of the inputted signal is
SYNC IS OUT OF RANGE
outside of the response parameters of this unit. Please confirm
ONfHkHz fVHzthe specs for this unit or the signal source specs.
The internal portion temperature is rising. Please turn the power
OFF, and allow the unit to cool down for approximately 20
minutes. After having confirmed the following items, then please
CHECK THE AIR FLOWresent the power to ON.
? Is there blockage of the air passage aperture?
? Is the air filter dirty?
? Does the peripheral temperature exceed 35C?
NOTES
Note 1: Although this message will be automatically disappeared after around 3 minutes, it will
reappear every time the power is turned ON.
Note 2: Lamps have a finite product life. Lamps are characterized by the fact that, after long hours of
usage, a lamp will no longer light up, or the lamp will break or burst, etc. This unit is equipped
with an automatic shut-down function, such that the power will automatically be turned OFF
when lamp usage time has reached 2,000 hours. Please be aware, however, that among lamp
types, there are major differences in product lifetimes, a lamp may thus fail to light even prior
to the functioning of the automatic shut-down function of this unit.
26 |
ACEC
HITACHI
