CD-DP2500W/DK2500W
OPERATION MANUAL
button and the X-BASS/ DEMO
0
OCLEAR AL� will appear.
To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets).If the display is not correct.If the operation is not correct.Press the ON/STAND-BY button to enter the stand-by mode.Whilst pressing down the button, hold down the ON/STAND-BY button for at least 1 second. lThe operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets.
Reset the microcomputer under the following con- ditions:lll12Caution: l
Illustration:CD-DP2500W
RESETTING THE MICROCOMPUTER
) button once to ad-) button once to ad-
) button to select the time) button to adjust the hour.) button to adjust the min-
or or
or or or
The 24-hour display will appear. (0:00 - 23:59)The 12-hour display will appear. (AM 0:00 - PM 11:59)The 12-hour display will appear. (AM 12:00 - PM 11:59)
???
Note that this can only be set when the unit is first in- stalled or it has been reset.Press the TUNING/TIME (vance the time by 1 hour. Hold it down to advance con- tinuously.When the 12-hour display is selected, OAM� will change automatically to OPM�.Press the TUNING/TIME (vance the time by 1 minute. Hold it down to change the time in 5 minute intervals.The hour setting will not advance even if minutes advance from O59� to O00�.The clock starts operating from O0� second. (Seconds are not displayed.) And then the clock display will disappear after a few sec- onds.
Press the ON/STAND-BY button to enter the stand-by mode.Press the CLOCK button.Within 5 seconds, press the MEMORY/SET button.Press the TUNING/TIME (display mode. O0:00�OAM 0:00�OAM 12:00�lPress the MEMORY/SET button.Press the TUNING/TIME (llPress the MEMORY/SET button.Press the TUNING/TIME (utes. llPress the MEMORY/SET button. lThe time display will appear for about 5 seconds.The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is discon- nected. If this happens, follow the procedure below to change the clock time.Press the CLOCK button.Within 5 seconds, press the MEMORY/SET button.Perform steps 6 - 9 above.Perform steps 1 - 2 in the section ORESETTING THE MI- CROCOMPUTER�.Perform steps 1 - 9 above.
In this example, the clock is set for the 24-hour (0:00) system.123456789To see the time display:Press the CLOCK button.lNote: lTo change the clock time: 1 2 3To change the time display mode: 1 2
Illustration:CD-DP2500W
(Main unit operation)
SETTING THE CLOCK
� 8 � |
ACEC
SHARP
