CD-ES600VSystem connections (continued)
ENGLISH
! Setting the FM/AM span selector! Demonstration mode
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration
mode:
When the unit is in the power stand-
by mode (demonstration mode),
press the X-BASS/DEMO button.
The demonstration mode will be
cancelled and the display will disap-
pear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS/
DEMO button again.
Note:
When the power is on, the X-BASS/DEMO button can be used to se-
The International Telecommunication Union (ITU) has estlecta tblhies heextdra bass mode.
that member countries should maintain either a 100 kHz or a 50 kHz
interval between broadcasting frequencies of FM stat ions and 10
kHz or 9 kHz for AM station. The illustration shows! thExe 5te0rn/9 kal FHzM aerial
zones (regions 1 and 3), and the 100/10 kHz zone (regiUse an on 2).external FM aerial if you require better reception.
Before using the unit, set the SPAN SELECTOR switch (Consulon the reart your dealer.
Preparation for Use
panel) to the interval (span) of your area.
To change the tuning zone:External
FM aerial
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
"For 50 kHz FM interval (9 kHz in AM) 50/975 ohm
"For 100 kHz FM interval (10 kHz in AM) 100/10coaxial cable
3 Whilst pressing down the button and the X-BASS/DEMO but-
ton, press the PRESET button until "CLEAR AL" ap-
pears.Note:
When an external FM aerial is used, disconnect the supplied FM
Caution:aerial wire.
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
E-13
04/2/23CD-ES600V(Z)E2.fmTINSZA060AWZZ |
ACEC
SHARP
