INSTALLATION
Power supply/MainsInserting batteries in the remote controlEnglish
AC MAINS
The type plate is located on the rear of the set.
1 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does not,
consult your dealer or service organisation.
2 Make sure all connections have been made before2x AA, LR6, UM-3 / 1,5 V
switching on the AC power supply.
3 Connect the power cord supplied to AC POWER ~ and to the
wall outlet. This switches on the AC power supply.
4 Press ON/OFF to switch on the set.
� PHILIPS CD RECORDER will be displayed.
Y Press ON/OFF again to switch off the set.
Y Press y on the remote control to switch the set to Standby
mode.
When the set is switched to standby, it is still consuming
some power. To disconnect the set from the power1 Open the battery compartment cover.
completely, remove the power plug from the wall outlet.
2 Insert 2 batteries (AA, LR6 or UM-3; as supplied) as shown.
For users in the U.K.: please follow the instructions on3 Replace the cover.
page 3.
Note: We recommend you use 2 batteries of the same type
and condition.
Setup recommendations
Batteries contain chemical substances, so they should
� Place the set on a solid, vibration free surface.be disposed of properly.
� Make sure there is sufficient space around the set to
prevent overheating.
� Do not place the set near a source of heat or in direct
sunlight.
� Do not use the set under extremely damp conditions.
� If the set is placed in a cabinet, make sure that a 2.5 cm
space remains free on all sides of the CD recorder for
proper ventilation.
� Active mobile phones near to the set may cause
malfunctions.
16 |
ACEC
PHILIPS
