ROBO START INSTRUCTIONS:SPECIFICATIONS:
IN SINGLE-AUTO CUE MODE:GENERAL:
Use ROBO START(26) in SINGLE-AUTO CUE MODE(18) to alternateType................................................................... ........Compact Disc Player
play between the CDX-04?s two CD players (one track from one side,Disc Type......................................Standard Compact discs (12 cm & 8 cm)
then one from the other). In SINGLE-AUTO CUE MODE(18) play startsTime Display.........................Track Elapsed, Track Remain, or Total remain
immediately with no blank or ?dead? space. ROBO START(26)Variable Pitch.............................. .? 4, 8 ,16 %Slider with Resume Switch
causes one side of the CD player to play when the other side isPitch Bend..........................................................................? 4% Maximum
paused.Instant Start..................................................................Within 0.03 seconds
Track Selection.......................................................................1 to 99 Tracks
1. Engage SINGLE AUTO CUE MODE(18) with the SINGLE(18) button.Installation......................................................................................19" each
Dimensions..........................................................................19" x 3.5" x 10"
2. Press the ROBO START(26) button to activate ROBO START. Play willWeight entire Unit................................................13.69 lbs. (6.21 kg)
alternate between the two CD players. At the end of a track, the
playing side pauses and the other CD deck plays a track. At the end ofAUDIO SECTION:
this track, the playing side pauses and the first deck resumes play.Quantization........................................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate..........................................................................8 Times
IN CONTINUOUS MODE OR DURING NORMAL PLAY:Sampling Frequency.......................................................................44.1 kHz
If you use the ROBO START(26) function without SINGLE-AUTO CUEFrequency Response..........................................................20 Hz to 20 kHz
MODE (in CONTINUOUS MODE or during normal play), CD deck doesDigital Output....................................................................................IEC958
not alternate automatically. The PLAY/PAUSE(12) button must beTotal Harmonic Distortion..................................................Less Than 0.05%
pressed on the playing deck for the second track to play.Signal to Noise Ratio.........................................................................85~86 dB
Dynamic Range..................................................................................85~90 dB
1. During normal play, set a CUE POINT on the other side of the CDChannel Separation...............................................................85~86 dB
player.Output Level........................................................................2.0 +/- 0.2 V R.M.S.
Power Supply...........................................................AC 115/230V, 60/50 Hz
2. Press the ROBO START (26) button to activate ROBO START (the
button will blink).SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT NOTICE FOR
PURPOSE OF IMPROVEMENT.
3. Press PLAY/PAUSE (12) button on the playing side to begin play from
the cue point on the other side.
NOTE: IF PAUSED DURING PLAYBACK, IN THE MIDDLE OF A TRACK. WHEN THAT TRACK
ENDS, PLAY WILL BEGIN FROM THE MIDDLE OF THE TRACK WHERE PLAY WAS
PAUSED.
TROUBLESHOOTING:
?If the disk will not play, check to see if the disc was loaded
correctly (label side up). Also, check the disc for excessive dirt,
scratches, etc.
?If the disc turns but there is no sound, check the cable
connections. If they are okay, check your amplifier or receiver.
?If the CD skips, check the CD for dirt or scratches. Do not
assume that the CD player is defective. CDs that are recorded
improperly tend to skip on most or all CD players. Before
sending the unit in for repair playa CD that you are sure playsIN THE USA: IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT, PLEASE CALL 1 (732) 738-9003 FOR
GEMINI CUSTOMER SERVICE. DO NOT ATTEMPT TO RETURN THIS EQUIPMENT TO YOUR DEALER.
properly.
(6) |