Appendix
TROUBLESHOOTING
If you believe your CD player is failing to work properly, check the following troubleshooting table for tips. Sometimes simple mistakes
in setup or operation may appear like serious problems. There are also times when the problem in question may be caused by
something else other than your CD player, and at times like these you should check any other electronic devices being used at the
same time.
If the problem in question continues to persist even after checking the troubleshooting table below and taking whatever corrective
action is recommended, contact your nearest Pioneer Service Station or contact the store from which you purchased your player for
further assistance.
Description of problemPossible cause of problemRecommended action
A disc fails to be ejected even after the� Power cord has not been plugged in.� Plug in power cord.
EJECT button has been pressed.� EJECT button is broken.� See p. 11.
Playback comes to a halt almost� Disc has been inserted upside down.� Reinsert with label side facing upward.
immediately after it begins.� Disc is dirty or covered with condensation.� Wipe disc to remove dust or
condensation.
No sound is output.� Power cord has come loose or has not been� Plug in power cord properly.
properly plugged in.� Check switch and volume settings on
� Audio mixer is not working properly.audio mixer.
� Jacks or jack plugs are dirty.� Wipe away dust or dirt and reinsert plugs.
� Player is currently in pause mode.� Press the PLAY/PAUSE button (3/8) to
begin playback.
Sound is distorted or full of noise.� Output cord has not been properly plugged in.� Connect output cord to line input jack of
� Jacks or jack plugs are dirty.audio mixer. Do not connect to
� Player is subject to noise from a nearbymicrophone jack.
television set.� Wipe away dust or dirt and reinsert plugs.
� Turn off power to television set or move
television set further away from CD
player.
A large amount of noise is generated� Disc is seriously warped or scratched.� Replace with new disc.
when playing back a certain disc or� Disc is unusually dusty or dirty.� Wipe away dust or dirt from disc.
discs. Playback halts unexpectedly.
Track searching fails to halt with auto� Track searching sometimes takes longer than� Press the TIME MODE/AUTO CUE
cueing turned on.expected when the length of silent portionsbutton and hold the button down for 1
between tracks is unusually long.second or longer to turn auto cueing off.
� If the length of a silent portion between two
tracks is longer than 10 seconds in duration,
the second track cannot be played back
unless auto cueing is turned off.
Back cueing fails to work when the� No cueing point has been defined.� Specify the desired cueing point. (See p.
CUE button is pressed during playback.16.)
Unable to produce loop playback by� No cueing point (i.e., starting point) has been� Specify the desired cueing point. (See p.
pressing the LOOP OUT/EXIT button.defined.16.)
Television pictures are distorted or� Interference caused by CD player.� Turn off the power to the CD player or
noise appears in FM broadcasts.move the player further away from the
radio or television set.
Disc is not rotating even though power� Disc rotation is automatically halted when no� Press the PLAY/PAUSE button (3/8) to
has been turned on.operation is performed for 80 minutes orbegin playback. Alternatively, press the
longer when in pause mode.EJECT button (0) to eject the disc.
� There may be times when the CMX-5000 fails to operate properly as a result of static electricity or some other form of interference
from an outside source. If any such problem occurs, turn off the power to the CMX-5000, wait for the currently inserted disc to
come to a full stop, and then turn on the power again to see if that fixes the problem in question.
� The CMX-5000 cannot be used to replay partially-written CD-R or CD-RW discs.
� The CMX-5000 cannot be used to replay non-standard-shaped discs or any discs other than 5 inch/12 cm discs or 3 inch/8 cm discs
which have been inserted into an 3 inch/8 cm disc adapter. (Note that attempting to replay such discs may result in damage or
breakdown.)
� The BPM value measured by the CMX-5000 may differ from the BPM value recorded on a CD or from our DJ mixer, but this
difference is a result of differences in the BPM value measurement method; not a result of a fault with the player.
<DRB1254>19 |
ACEC
PIONEER
