SERVICE AND ADJUSTMENT
Connect BLACK grounding cable to
TO ATTACH JUMPER CABLESnegative (-) battery terminal with remain-
ing hex bolt and hex nut.
Connect each end of the RED cable to
Tighten securely.
the POSITIVE (+) terminal on each
Close terminal access doors.
battery, taking care not to short against
Lower seat.
chassis.
Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of the fully
charged battery.
TERMINAL
Connect the other end of the BLACK
GUARD
cable to a good CHASSIS GROUND,
away from the fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER
BLACK cable first from chassis and then
TERMINAL
from the fully charged battery.ACCESS
DOORS
RED cable last from both batteries.
CZ-22
FIGURE 18
REPLACING BATTERY (See Fig. 18)
TO ADJUST PARK BRAKE
Before making any adjustments:
WARNING
NOTE: Make sure the brake arm is engaged into
Do not short battery terminals bybrake sprocket on both sides. You can push the
allowing a wrench or any other object tomower to make it engage into the sprocket. See
contact both terminals at the same time.Fig. 19.
Before connecting battery, remove metal
With the park brake in the on position,
bracelets, wristwatch bands, rings, etc.
the compression spring should be 2"
Positive terminal must be connected firstfrom the "U" shaped brake arm to the
to prevent sparking from accidentalwasher. See Fig. 19. If not, use two
grounding.wrenches, one to hold the bolt and one to
turn the nut to attain the 2".
Lift Seat and rotate forward.BRAKE
IZT BRAKE
Open terminal access doors.SPROCKET
ARM
RIGHT SIDE
Using two 1/2" wrenches disconnectRIGHT SIDE
SPRING
BLACK battery cable then RED batteryADJUSTMENT
NUT
cable.
Using 7/16" wrench, remove terminalBRAKE
guard.COMPRESSION
SPRING
Carefully remove the battery from the
mower.
Install new battery with terminals in the
same position as the old battery.
Reinstall terminal guard"U" SHAPED
BRAKE
First connect RED battery cable to
ARM
positive (+) battery terminal with hex bolt
CZ-23
and hex nut.FIGURE 19
31 |
ACEC
HUSQVARNA
