3.4.2 Setting the auto memory write
function
This function is used to automatically assign the frequency that has been
received during scanning in the PMS mode, to the memory bank.
1Call up the scanning program.
PMS
SET
Press the key to enter the PMS mode. Select a program bank number. The
programmed scanning will start.
2Set the auto memory write function.
108&3Press the F key, and then press
'
AUTO MW
.1.40/*4&5the key 5with shown on"650 .3 83
42-70-ST O P
43$3.8the display. The AUTO MW)7'0.STARTA9
"#
screen will appear.
-".1
Point the arrow at START using the UP/DOWN key, and
%08/61
select a program bank using the dial.
4&5
55HELPTF
&45&1"3.&Press the .0%./"ENTkey. The programmed scanning will
2 C
1.8,-RF
.*$"65056"#4Nstart and the received frequency will be assigned to theSC
4*0 $5$44
$35automatically selected memory bank.1395'
To stop the auto memory write function, point the arrow at STOP on the AUTO
TF
MW screen, and then press the ENT key.
Note: The settings for the radio type, frequency step, attenuator, and CTCSS
decoding function, which were completed in the PMS mode, will be stored on
the memory channel.
3.4.3 Setting memory scan skip
This setting specifies memory channels to be skipped while scanning in the MR
mode. The memory scan will not stop on these frequencies even if a signal is
present.
� To skip memory channels
3945MRMW
108&3Press the key to get the
'
.070-1./*4&5MR mode. Then set the memory4WFM
2-
4
43$)7'0.channel where skip channels are3.8A18 4 . 5
16"#-"
.1
%08/to be set. Press the Fkey to
"535HE"L.P&4&5
12,-RF.0%&45&1./C SKIP
.*$"650.84564"#C4SNdisplay , followed by the CLR key (or press only the
13*0 $5$45'
78'4$35569/&ENTSKIP
4,*13&$CLR0key). SKIP will be displayed to indicate theMICCLR
INTERLELCEIVERDJ-X2channel will be skipped during IGENT
the memory scan.
72SKIP
Pressing the CLR key again will cancel the skip setting. |
ACEC
ALINCO
