DM1295
MIXER FEATURES
22
23
21
1920
INPUTS
1. Input Toggle Switches - select which source will be live to that
8. Treble and Bass Controls - for fine-tuning the tone of your
channel based on what you have connected to the rear panelvoice through the sound system. The controls are detented for
input section.setting tone "flat".
2. Input faders - control individual source levels in the mix.9. DJ Mic Gain Control - for volume adjustment of the
Note: Never use spray cleaners on the slide controls. ResiduesNeutrik? ?Combo? connector on the faceplate.
cause excessive dirt build-up and this will void your warranty.10. Mic 2 Gain Control - for volume adjustment of the 1?
In normal use slide controls can last for many years. If they
input on the rear panel.
malfunction (usually because of a dirty or dusty environment)
consult a professional technician.11. Mic Off/On/Talkover Switch. Off/On turns Mic 1off
and on. Mic 2 is controlled only through the Mic 2 Fader.
3. Channel Cue Assign - are used to route Pre Fader Level (PFL)
channel audio to the Headphone Section. The channel faders doTalkover turns down the input level of your music
not control the Cue volume.sources from Channels 1-4. Talkover is very useful for
4. Effect Send (Channels 1-4). Depress these buttons when youmaking announcements without adjusting any levels.
want the signal from any input channel to be routed to theTry using this feature for audience participation when
sampler on the Send Out Jacks.you want the music to temporarily cease and the audience
to be heard - ?YEAH!?
CROSSFADER
5. Crossfader Assign Knob - determines which input channel willOUTPUTS
be heard when the crossfader is moved towards the knob. With
12. Master Fader - controls the overall output level.
the crossfader centered, both assigned channels are live. Use the
crossfader for fast and seamless segues from one selected13. Stereo/Mono toggle - adjusts the Master output for stereo or
channel to the other.mono operation.
6. Replaceable Crossfader - achieves clean segues between the14. Booth/Zone Fader - controls speaker volume for a remote zone
two input channels selected by the Crossfader Assign.or booth monitors. NOTE: This can also be used to supply line
level audio to a lighting controller or to lights that are sound
Note: The crossfader is a user replaceable item and subject to
wear. Excessive force can wear out the fader quickly. This isactivated.
15. Stereo Auto Peak Hold Level Indicator- quickly and
not a warranted item. In case of failure. Simply unscrew the two
large screws that hold it in place, lift it out and disconnect itsaccurately tracks level of audio output. The red LEDs for +3dB,
cable. Re-attach the new crossfader and screw the mounting+5dB and +8dB hold program peaks for a second or two. With
peak metering, it's OK to be "in the red" as long as +5dB or
plate back onto the unit - you?re back in business!
MICROPHONE+8dB aren't constantly lit. When using as a master output
meter, set the crossover, equalizer and power amp inputs to
7. Neutrik? ?Combo? connector - allows connection of either aavoid distortion at each step in the audio chain. Proper attention
1/4? jack or an XLR jack. This is ideal for connecting an XLRto the peak meter results in the punchiest possible sound without
gooseneck directly into the mixer.audible distortion.
- The Leader in DJ Technology
?2000 Industries- 4 -http://www.numark.com |
ACEC
NUMARK
