Connecting the Power/
Turning on the DVD Receiver
Before connecting
STANDBY/ON
Y Make sure that all the connections from pages 18 to 25 are
ON indicator
complete (the connection to the TV is required).
STANDBY indicatorDisplay
Y Turning on the DVD Receiver may cause a momentary power
surge, which might interfere with other electrical equipment such
PROGRESSIVE SCAN
as computers. If this happens, use a wall outlet on a differentTHEATER DIMENSIONAL
IPM
circuit.
Setting the Clock Display
Connect the power cord to the AC
1To display the clock while in Standby mode, hold down the
INLET of the DVD Receiver.
STANDBY/ON button for at least 2 seconds when switching from
AC INLETOn to Standby mode.
Note
Displaying the clock in Standby mode consumes the same amount of
power as in the On mode.
Connect the power cord to a wall
2
outlet.
The DVD Receiver enters the standby
mode and the STANDBY indicator lights
up.
AC INLET
to wall outlet
Press STANDBY/ON on the DVD
3
UnitReceiver or ON on the remote
controller to turn on the DVD
Receiver.
The light and display on the DVD
ReceiverOs front panel light. At the same
time, the STANDBY indicator goes off and
the ON indicator lights up.
ON indicator
Remote
ControllerSTANDBY indicator
ON
Y To put the DVD Receiver in the standby
mode, press STANDBY/ON on the DVD
Receiver, or STANDBY on the remote
controller. Be sure to set the volume to
minimum before putting the DVD
Receiver in the standby mode for the
next use to avoid sudden loud sound
reproduction.
Y While in the STANDBY mode, the DVD
Receiver can receive signals from the
remote controller.
Y Setting the STANDBY button on the
remote controller to standby does not
shut off the power completely.
2626 |
ACEC
ONKYO
