Troubleshooting
Processor ResetPower Control Button 2. Next, press andIf the system is still operating incorrectly, there
In the rare case where the receiverOs operation hold the Tone Mode 6 and the FM Modemay have been an electronic discharge or
or the displays seem abnormal, the cause maySelector @ buttons for three seconds.severe AC line interference that has corrupted
involve the erratic operation of the systemOsthe memory or microprocessor.
memory or microprocessor.The unit will turn on automatically and display
the RESET message in the MainIf these steps do not solve the problem, consult
To correct this problem, first unplug the unitInformation Display U.an authorized JBL service center.
from the AC wall outlet and wait at least threeNOTE: Resetting the processor will erase anyIn the event that you forget the password for
minutes. After the pause, reconnect the ACconfiguration settings you have made for speak-the DVD600II, you may reset it to the factory
power cord and check the unitOs operation. If theers, output levels, surround modes and digitaldefault by following this procedure: In Standby
system still malfunctions, a system reset mayinput assignments, as well as the tuner presets.mode, press the Search Reverseand
clear the problem.After a reset, the unit will be returned to theSkip Forwardbuttons on the front panel
To clear the receiverOs entire system memoryfactory presets, and all settings for these itemssimultaneously for more than 3 seconds. The
including tuner presets, output level settings,must be reentered.Information Display will light, and a
delay times and speaker configuration data, firsttest pattern will appear on your TV. Press the
put the unit in Standby by pressing the SystemSystem Power Controlto proceed.
SYMPTOMPROBABLE CAUSESOLUTION
DCR600II does not function when Main Y No AC PowerY Make certain AC power cord is plugged into
Power Switch is pusheda live outlet.
Y Check to see whether outlet is switch-controlled.
DVD600II does not turn on Y Main Power Switch turned offY Press in Main Power Switch.
Y No AC powerY Check AC power plug and make certain any switched
outlet is turned on.
Display lights, but no soundY Intermittent input connectionsY Make certain that all input and speaker connections
are secure.
Y Mute is onY Press Mute Button c.
Y Volume control is downY Turn up volume control.
Unit turns on, but front panel Y Display brightness is turned offY Follow the instructions in the Display Brightness section
display does not light upso that the display is set to VFD FULL.
No sound from any speaker;Y Amplifier is in Protection mode Y Check speaker wire connections for shorts at receiver and
light around power switch is reddue to possible shortspeaker ends.
Y Amplifier is in Protection mode Y Contact your local JBL service center.
due to internal problems
No sound from any speakerY No audio signal is being transmittedY Check that DCR600II is on and a source is playing.
to the speakersY Check all wires and connections between the DCR600II
and speakers. Make sure all wires are connected. Make sure
none of the speaker wires are frayed, cut or punctured.
Y Review proper operation of the DCR600II.
Y If in DVD mode, make sure that Y Check Input assignment for DVD Input. DVD Input should be
analog input is not accidentally assignedset to COAX 1 and the DVD600II Digital Output should be
connected to Coaxial 1 Digital Input ?on the DCR600II.
Y Intermittent connectionsY Check all audio connections.
Y Incorrect digital audio selectionY Check digital audio settings.
Y DVD disc is in Fast or Slow modeY There is no audio playback on DVD discs during
Fast or Slow modes.
66 |
ACEC
JBL
