STANDARD CONNECTIONS
MULTICHANNEL SOUND FOR HOME THEATRE
DIGITAL AUDIO (STEREO) SOUND
CONNECTION
For this connection, which produces the highest possible ste-
reo sound quality, you need an audio amplifier with digital
DIGITAL AUDIOinput, and the digital output of the player must be activated
IN
(see Settings p. 20). Connect the playerOs digital audio output
RECEIVER
to the corresponding input on the amplifier. In this case, do
212018161412108642not use the playerOs audio Left and Right outputs.191715131197531
DIGITAL AUDIO
CABLENTSC/PAL SETTING
Use the NTSC/PAL switch on the rear of the player to set the
Video CD and player menu according to the standard used by
For multichannel sound, your player provides both digital andyour TV-set.
analog audio outputs.
NOTE
DIGITAL (MPEG 2 MULTICHANNEL OR DOLBY
- The video output standard for video CD and DVD-Video discs
DIGITALa) MULTICHANNEL SOUND
most corresponds to the disc being played.
1 For this, which provides the highest multichannel sound
quality, you need a digital multichannel A/V receiver.
CONNECTING THE POWER SUPPLY
2 Connect the digital audio output on the rear of the player to
a suitable input on the receiver using a digital audio cable1 Plug the female end of the power cord supplied into the
(available as option). In this case, do not use the playerOs
Power connector on the rear of the player.
audio Left and Right outputs.
2 Plug the male end of the cord into an AC outlet.
3 You will need to activate the digital output of the player
(See Settings p. 20).
NOTE
4 The audio format of the digital output is dependent on the- The player automatically adjust to the local AC voltage.
audio format of the selected audio stream. Make sure that
the selected audio stream matches the capabilities of the
- When the player is in the OOFF� position, it still consumes
receiver connected to the digital output.
some power. If you wish to disconnect your player comple-
tely from the power supply, withdraw the plug from the AC
ANALOG (DOLBY PRO LOGICa) MULTICHANNELOutlet.
SOUND
CAUTION
1 If your TV set has a Dolby Pro Logica decoder, simply hook
Only qualified service personnel should remove the
up the player to the TV using the A/V Euroconnector, orcover or attempt to service this device.
Video (CVBS) and audio connections as on p. 9.
2 If not, make the A/V Euroconnector, or Video (CVBS) con-
nection to the TV p. 9, and connect the playerOs audio Left
and Right outputs to suitable inputs on a Dolby Pro Logica
Audio/Video receiver, using the cable supplied.
3 For speaker connections, follow the instructions given in
the TV set or A/V receiver user manual.
NOTE
- You cannot use the RF Modulator option for home theatre.
- If the audio format of the digital output does not match the
capabilities of your receiver, the sound will be muted.
10english |
ACEC
PHILIPS
