Details of Servicing and Troubleshooting > Firmware
(3) Main firmware updating procedure
1) Write the main firmware data to a CD-R.
2) Insert the firmware disc: The screen for verifying update will appear
Update Disc.
(Fig. 3-1-7).
Run: REC KEY 3 times
3) Press the REC button on this DVD recorder three times: Both the
current version of main firmware and the version of main firmwareOpen: Other KEY
on the disc will appear on the screen (Fig. 3-1-8).
4) Pressing the REC button on this DVD recorder will start writingFig. 3-1-7
(Fig. 3-1-8).
Current Version
To cancel writing, press the OPEN/CLOSE button and remove theVersion=040731APV Cware=LG17 BSP=1
New CD Write Version
disc.Version=040731A cware=LG17 BSP=16
5) When updating is complete, the tray will open automatically:
RECKEY:WRITE OPEN:CANCEL
Remove the disc.
6) Turn the DVD recorder off and then on: The firmware is now
Fig. 3-1-8
updated.
(4) Drive firmware updating procedure
1) Write the drive firmware data to a CD-R.
2) Insert the firmware disc: The screen for verifying update will appear
(Fig. 3-1-7).
3) Press the REC button on this DVD recorder three times: The data
Current Loader Version
on disc will be read, the Firmware Update screen will appear, andDVD+-R/RW RL-02A a.30
New CD Write Loader Version
the drive firmware version along with the version of drive firmwareDVD+-R/RW RL-02A a30
on the disc, will appear on the screen (Fig. 3-1-9).
RECKEY:WRITE OPEN:CANCEL
When reading the data on disc is complete, the disc tray will open
automatically: Remove the disc.
Fig. 3-1-9
4) Press the REC button on this DVD recorder.
To cancel writing, press the OPEN/CLOSE button.
5) Turn the DVD recorder off and then on: The firmware is now
updated.
3-1-4 Setting to defaults at the factory
Perform the following procedure to reset this DVD recorder to the
initial status when it was shipped from the factory (defaults):
1) Press the SETUP button on remote control and use the cursor
buttons to choose the GENERAL menu.
2) Press the cursor button to move to the second level.
3) Use the cursor buttons to choose ?Factory Set?, choose the SET
icon, and then press the ENTER button.
3 - 3 |
ACEC
HITACHI
