Rinse aid If you are using dishwasher detergent that already contains
Rinse aid is automatically added during the last rinse, ensuringrinse aid, it is necessary to deactivate the rinse aid
dispenser, in order to avoid a double dosage.
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
Deactivation/activation of the rinse aid
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting. dispenser
(The dishwasher must be switched off)
Factory setting:rinse aid dispenser activated
Filling with rinse aid
1.Open the container by pressing the release button (A). When the rinse aid dispenser has been deactivated, the
2.Add the rinse aid until the container is completely full. The rinse aid indicator light on the control panel is
automatically deactivated.
maximum level for filling is indicated by "max".
1.Press the On/Off button. The On/Off indicator light
illuminates (setting mode).
If a programme button indicator light is on, this means that
a washing programme has been set. The programme must
be cancelled: press simultaneously the function buttons 2
and 3for about 2 seconds.
All the indicator lights will turn off (except for the On/Off
indicator light and eventually salt and rinse aid indicator
lights) indicating that the set programme has been
cancelled and the machine is now in setting mode.
2.Press simultaneously function buttons 2 and 3, until the
Ensure that the lid is closed after every refill. indicator lights of the function buttons 1, 2 and 3 start
flashing.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next3.Press the function button 2, the indicator lights of function
wash. buttons 1 and 3 turn off while the indicator light of the
function button 2 goes on flashing, at the same time the
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.indicator light END illuminates indicating that the rinse aid
dispenser is active.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.4.To deactivate the rinse aid dispenser, press the function
button 2 again, the indicator light END turns off, indicating
that the rinse aid dispenser has been deactivated.
Adjusting the dose
5.To memorise the operation, switch off the dishwasher by
According to the finish and drying results obtained, adjust thepressing the On/Off button or wait about 60 seconds after
dose of rinse aid by means of the 6 position selector (positionwhich the dishwasher will automatically return to setting
1 minimum dosage, position 6 maximum dosage). mode.
The dose is factory set in
position 4.To activate the rinse aid dispenser follow the above
instructions until the indicator light END illuminates.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
8 |
ACEC
ZANUSSI
