aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
4.Pattern mode
Convenient functions for
Motion sequence
Playing a motion sequenceediting patterns
A motion sequence can be played back in one of the followingIf you wish to save the pattern you edit using these func-
two ways, and you can select the playback method indepen-tions, you must perform the Write operation before select-
dently for each part.ing a different pattern or turning off the power.
SMOOTH: Knob values will be connected smoothly, and the
Erasing phrase pattern data from
sound will change smoothly.
TRIG HOLD (trigger hold): The value of the motion sequence
a part
knob will be held at the note timing of that part.
To erase the phrase pattern data for the selected part, you can
use one of the following two methods in addition to turning
Playback the motion sequence
with Smooth settingeach of the sixteen step keys off.
Knob movements when the motion
Erasing data during playback or
sequence was recorded
12345678 9 10 11 12 13 14 15 16recording (ERASE)
OnOnOnOnOnOnOnOn
Playback the motion sequence
1. Press the PART SELECT key to select the part from which
12345678 9 10 11 12 13 14 15 16withrTig Hold setting
OnOnOnOnOnOnOnOnyou wish to erase data.
2. During playback or recording, hold down the SHIFT key and
press the Rec key. As long as you continue holding these keys,
12345678 9 10 11 12 13 14 15 16
OnOnOnOnOnOnOnOntrigger data will be automatically be erased from the selected
part.
Performing this operation will not affect the pitch and gate
There will be no effect when the Motion Sequence LED is
time data.
dark (off).
Recording a motion sequence
You can record knob movements (motion sequence) for each1
part. When recording a motion sequence, only one knob is valid2
for each part. If you record a motion sequence on the same part
using a different knob, the effect of the previously recorded knob4.Pattern mode
will disappear.
2
For the recording procedure, refer to p.18 "Using a motion se-
quence" in section 3. Basic operation (Quick Start).
Motion sequences are recorded in realtime while you lis-
Erasing all data from a part (CLEAR PART)
ten to the playback. It is not possible to partially modify a
motion sequence after it has been recorded. You will needThis operation erases all phrase pattern and motion sequence
to keep trying until you record a motion sequence to ydata at once.our
liking. (Refer to p.31 "Erasing motion sequence data from
1. If the pattern is playing, press the Stop/Cancel key to stop
a part.")
playback.
2. Press the PART SELECT key to select the part whose data
you wish to erase.
Checking motion sequence data
3. Hold down the SHIFT key and press step key 12 (CLEAR
Hold down the SHIFT key and press the MOTION SEQ key. If
PART). (Key 12 will blink.)
motion sequence data has been recorded in the selected part,
step keys 1, 2, 3, 4 will light.4. Once again press step key 12 to clear the data.
It is not possible to check for motion sequence data dur-To cancel without clearing the data, press the Stop/Cancel key.
ing playback, recording, or Pattern Set Play.
When you perform this operation, the pitch of all steps will
be set to "C4," and the gate time to "1.00."
2
3,4
3
29 |