BEFORE USING THE DRYER / CONNECTIONS
1. Removing the packaging and checkStacking kit
? After unpacking, make sure that the dryer is Your dryer can be stacked on top of your front
undamaged. If in doubt, do not use the dryer. loading washing machine. To do this, use stacking
Contact After-Sales Service or your local retailer.kit AMH 542, available at your dealer.
Keep the packaging materials (plastic bags, Minimum housing dimensions:
polystyrene parts, etc.) out of reach of children, as Width:600 mm
they are potentially dangerous.
Height:850 mm
2. Electrical ConnectionsDepth:560 mm
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer?s instructions and current standard
safety regulations.
Electrical connection must comply with local
Electricity Board regulations.
Voltage information, power consumption and the
required fuse protection is shown on the rating
plate mounted at the rear of the dryer.
The manufacturer cannot accept any liability for
personal injury or damage to property resulting
from failure to adhere to these instructions.
The dryer must be earthed as prescribed by law.
Do not use extension leads or multiple adaptors.
Before any maintenance on the dryer disconnect it
from the mains supply.
Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
Mains cable replacement is only to be carried out by
After-Sales Service.
After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be
possible with a switch.
3. Installation
Do not install your dryer where it can be subject
to extreme conditions, such as: poor ventilation,
temperatures around freezing (or above 35°C).
Remove the protective foil from the control
panel.
Stability:
When installing the dryer always carefully level the
dryer adjusting the two feet and check the correct
levelling with a spirit level.
To built in the dryer
For security reasons do not remove the
worktop.
Connect the dryer to an external ventilation
system in order to prevent steam from damaging
your furniture during the years.
10 |
ACEC
LADEN
