Install properly.. . Remove sales labels.. .
Remove the Consumer Buy Guide label and other
Inside labels before usrng the refrigerator. Any glue
-C left can be taken off wrth rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
1. Allow % inch (1.3 cm] space on each side and at
the top for ease of installation.
2. The refrigerator back can be flush against the watl.
3. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
Clean your refrigerator before using it. See clean-
opened wider. ing instructions on page 9.
Level refrigerator-freezer.. .
Plug it in.. .
3.prong 3.prong
grounding grounding type type
wall wall receptacle receptacle
rong
ing plug
Refrigerotol Refrigerator
Power Power Cord Cord
Right to Raise;
Left to Lower
RECOMMENDED GROUNDING METHOD
I. Remove base grille [see page 7).
2. To raise front, turn each screw to the right A 115 Volt 60 Hz., AC only, 15 or 20 ampere fused
3. To lower front, turn each screw to the left. electrical supply is required. It is recommended that a
4. Check with level. separate circuit serving only this appliance be
provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.
4 |
ACEC
WHIRLPOOL
