If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 lett. A) and the
"crown" (Fig. 1 lett. B) are in the correct position.
A
To put the flame out, turn the knob to the symbol z.
In the absence of electricity, ignition can occur
without the electrical device; in this case approachB
the burner with a flame, push the relevant knob
down and turn it anti-clockwise until it reaches the
"maximum" position.
Always turn the flame down or put it out before
taking the pans off the burner.
Carefully supervise cookings with fats or oil, since
these types of foodstuff can result in a fire, if over-D
heated.
Energy saving advicesFig. 1C
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a
bottom fitting the size of the burner used, so that flame will
not spread beyond the bottom of the vessel (see the tableBurnerminimummaximum
beside).diameterdiameter
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquidRapid180 mm.260 mm.
simmering.
Auxiliary80 mm.160 mm.
? Use only pans or pots with flat bottom.
Cleaning and Maintenance
Disconnect the appliance from the electricalPeriodic maintenance
supply, before carrying out any cleaning orPeriodically ask your local Service Centre to check the
manteinance work.
conditions of the gas supply pipe and the pressure
Wash the enamelled components with warm soapyadjuster, if fitted.
water. Never use abrasive cleanersTo ensure the good operation of the hob and its safety
Frequently wash the "caps" and the "crowns" with hotfeatures, it is necessary that the taps are periodically
soapy water, carefully taking away any built-up of food.lubricated.
Carefully wash the stainless steel components withzzzzz The periodic lubrication of the taps must be
water, then wipe them dry with a soft cloth.carried out by qualified personnel, which you
The pan supports are dishwasher proof.must refer to also in case of malfunctioning.
If the marks are particularly difficult to remove, use
common non-abrasive cleaners or specific products.
Never use steel wool pads or acids.
In models provided with electric ignition, this feature is
obtained through a ceramic "candle" and a metal
electrode (Fig. 1 lett. C). Keep these components well
clean, to avoid difficult lighting, and check that the burner
crown holes (lett. B) are not obstructed.
4 |
ACEC
ELECTROLUX
