SOMETHING NOT WORKING?
Beforecontacting Expert Appliance Care check the following points.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
SymptomSolution
No power to appliance- Check there is power at the socket.
- Check there is not a power cut by checking the
household lights.
- Check the fuse has not blown.
The light does not come on- Ensure that the bulb is correctly fitted.
- Replace the bulb if it has blown.
- Check the door light switch is not jammed.
The temperature in the fridge or freezer section is too- Check the thermostat control knob in the fridge is turned
highto the correct setting relative to ambient conditions.
- Check the ambient temperature is within the appliances
operating limits of 16uC to 32uC.
Relocate the appliance if necessary.
The compressor runs continuously- Adjust the thermostat control knob to give correct
temperature control. See page 4.
- Check that the doors are closed.
- Large quantities of food have recently been placed in
the cabinet and/or door is frequently opened.
- Check that air ventilation is not obstructed.
Excessive frost and ice has built up- Ensure the doors are not left open.
- Check that nothing is preventing the doors from closing.
- Is the door gasket intact and clean?
- Has advised periodic defrosting been carried out?
Noise- Refer to normal operating sounds.
If after the above checks, there is still a fault, call Expert Appliance Care.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a
charge if the fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service calls.
10 |
ACEC
ELECTROLUX
