CUSTOMER SERVICE AND SPARE PARTS
If the appliance is not functioning properly, checkY If your appliance is still not working properly after
that:making the above checks, contact the nearest
service centre.
Y the plug is firmly in the wall socket and the mains
power switch is on;To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
Y there is an electricity supply (find out by plugging
of your appliance which can be found on the
in another appliance);
guarantee certificate or on the rating plate located
Y the thermostat knob is in the correct position.
inside the appliance, on the bottom left-hand side.
Y If there are water drops on the bottom of the
cabinet, check that the defrost water drain
opening is not obstructed (see ODefrosting�
section).
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.100 mm
Appliance positioned under overhanging kitchen wallAB
units (see Fig. A).
Appliance positioned without overhanging kitchen
10 mm
wall units (see Fig. B).10 mm
NP007
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the
figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
PR153
38 |
ACEC
ELECTROLUX
