Water outlet hose connectionElectrical connection
The end of the drain hose can be connected in the followingInformation concerning the electrical connection is given on the
ways: rating plate on the edge of the dishwasherOs door.
1.To the sink outlet spigot, securing it to the underside of the Before plugging the appliance into the wall socket, make sure
work surface. This will prevent waste water from the sink that:
running into the machine. 1.The mains voltage and current rating at the site of
2.To a stand pipe provided with vent-hole, minimum internal installation match the nominal voltage and current rating
diameter 4 cm. given on the rating plate.
The waste connection must be at a maximum height of 60 cm2.The meter, fuses, mains power supply and wall socket can
from the bottom of the dishwasher. all take the maximum load required. Make sure that the
socket and plug are compatible without having to use any
The drain hose can face either to the right or left of thetype of adaptor. If necessary, have the domestic wiring
dishwasher
system socket replaced.
Ensure the hose is not bent or squashed as this could prevent
or slow down the discharge of water. To isolate the dishwasher from mains, remove the mains plug.
The sink plug must not be in place when the machine is
Important!
draining as this could cause the water to syphon back into theThe plug must still be accessible after the appliance
machine.
The total length of the drain hose, including any extension youhas been installed.
In case that the electrical cable has to be replaced,
might add, must be no longer than 4 metres. please contact your local Service Force Centre.
The internal diameter of the extension hose must be no
smaller than the diameter of the hose provided.The appliance should not be connected to the
electrical supply by means of an extension cable.
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than theSafety standards require the appliance to be
earthed.
diameter of the hose provided. The manufacture accepts no liability for failure to
Attention!observe the above safety precautions.
Our appliances are supplied with a security device to protect
against the return of dirty water back into the machine.
If the spigot of your sink has a "no return valve" incorporated
this can prevent the correct draining of your dishwasher.
We advise you therefore to remove it.
24 |
ACEC
ELECTROLUX
