DETAILED SECTION DESCRIPTIONSAugust 2nd,1995
PRINTING
Jam Detection *
ConditionError Code
When theWhen the registration sensor is not turned on within
standard2.0 seconds of the paper feed clutch signal. (The
cassette is usedstandard cassette mechanism does not use the paper9-07
feed clutch, but the cpu sends it a signal anyway, and
the jam timing starts from this signal.)
When theWhen the paper feed out sensor is not turned on
standard,within 2.6 seconds after the paper feed motor s9-08tarts to
optional paperfeed paper for printing (not for prefeed).
feed unit, optionalWhen the registration sensor is not turned off within X
100 sheetseconds after it turned on.
cassette, orX seconds = (paper length / 67.546) + 3 seconds9-08
bypass feed slot(67.546 mm/ s : paper feed speed)
is used
When theWhen the relay sensor in the paper feed unit is not
optional paperturned on within 2.0 seconds after the paper f9-50eed
feed unit is usedclutch is enabled.
When the registration sensor in the fax machine is not
turned on within 2.0 seconds after the paper f9-51eed
motor started.
When the bypassWhen the registration sensor is not turned on within 2
feed slot is usedseconds after the paper feed motor starts rotating for
printing.
(This error is not generated during prefeed, to allow
the users to change their minds after putting paper in9-80
this slot. When the bypass feed sensor is turned on,
the machine prefeeds the paper for up to 1 second
and stops feeding even if the registration sensor is not
turned on. If the registration sensor did not turn on at
prefeed, the machine checks for the above error.)
When the bypass feed sensor is not turned off within
11.9 seconds after it is turned on.
Using the same formula as above (error code 9-9-8108), it
works out that individual sheets cannot be longer than
about 60 cm.
When the 100When the registration sensor is not turned on within
sheet cassette is2.0 seconds of the paper feed clutch turning on.9-82
used.
2-34 |
ACEC
RICOH
