Finalizer96K Manual 01.99 28/01/99 16:23 Side 20
MAIN PAGE InsertsMAIN PAGE Inserts
INPUTI 1I 2NORMALIZEREXPANDERCOMPRESSORLIMITEROUTPUTINPUTI 1I 2NORMALIZEREXPANDERCOMPRESSORLIMITEROUTPUT
Black box indicates selected blockSelected band
Level barFrequencyGainBandwidth/SlopeInsert TypeBalance adjustBand levelAdjustable Cross-over
frequency
EQExternal InsertMS Encoding/DecodingSpectral Stereo Image
Instead of internal processing, one of the two Insert points may beMS miking technique or Mid/Side uses a forward-facingThis feature is only available in Finalizer 96
Basic operationset up for external processing. The External Insert may be Analog,directional mic and a side-facing bi-directional mic.
Press the PARAMETER keys to select frequency/gain/AES/EBU or S/PDIF depending on your Input choice.MS recording offers very good stereo imaging with the addedThis function allows you to control the stereo width of your
bandwidth/slope. benefit of excellent mono compatibility. Through the electronicsignal in three independent bands by adding or subtracting stereo
Turn ADJUST wheel to change values. Note: Asking for an External Insert is part of a preset. Enabling aprocess of MS Encoding and Decoding, the two mic signals caninformation. Selecting values above 0 (Normal) will enhance the
Press BAND keys to jump between the five bands.specific External Insert is part of the Global parameters. When anbe combined to create a stereo signal either before recording orstereo information in the selected band, while values below 0 will
Analog Insert is specified, the I/O interface levels are stored withon playback. The Finalizer offers MS Encoding and Decoding.reduce stereo information.
EQ Rangesthe preset.Use the CURSOR keys to select the desired parameter and dial
TypeFrequencyBandwidth/SlopeIf a preset containing an External Insert is called, and no such- MS Encoding will change a regular Left/Right signal into a the ADJUST wheel to change values.
Low Shelve19.95Hz to 5.01kHz3, 6, 9, 12 dB/Octthing is available in your current setup, the External Insert is Mid/Side signal. Note that enhancing the Stereo Image might reduce the overall
Bell-shaped filter 1 19.95Hz to 20kHz0.1 Oct to 4.0 Octdisabled but shown in the Insert page, until you change the Insert- The Fine Balance control will allow you to adjust the level. This can be compensated by increasing the level by 1-3dB
Bell-shaped filter 2 19.95Hz to 20kHz0.1 Oct to 4.0 Octconfiguration in the In or Out-page.relationship between the Mid/Side signals. in the Normalizer.
Bell-shaped filter 3 19.95Hz to 20kHz0.1 Oct to 4.0 Oct- MS Decoding will change a Mid/Side signal into a Left/Right
High Shelve501.2Hz to 20kHz3, 6, 9, 12dB/OctsignalTry enhancing the Stereo Image in the Mid and
- The Balance control will allow you to change the relationship High band, while leaving the Low band
Gain Range for all filters and Output: +/- 12dBbetween the Mid/Side signals. untouched. This will widen the vocal and cymbal
area while maintaining the punch from the
EQ BypassTry lowering the Mid signal by a few dB. This isbassdrum.
Press the OK key to bypass the Insert section.what is perceived as an enhancement of the
overall Stereo image.
Reset all filters by pressing both BAND keys
simultaneously.
2021 |
ACEC
OTHERS
