132990471_GB.qxd 19/07/2004 09:43 Pagina 8 (Nero/Process Black pellicola)
The inlet hose must not be lengthened. If it is tooThe drain hose must not be kinked.
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
designed for this type of use.
Important!
Before connecting up the machine to new pipework
or to pipework that has not been used for some time,
run off a reasonable amount of water to flush out any
debris that may have collected in the pipes.
Water drainageFor a correct functioning of the machine the
The end of the drain hose can be positioned in threedrain hose must remain hooked on the proper
ways:support piece situated on the top part of the back
Hooked over the edge of a sink using the plasticside of the appliance.
hose guide supplied with the machine. In this
case, make sure the end cannot come unhookedElectrical connection
when the machine is emptying.This machine is designed to operate on a 220-230 V,
This could be done by tying it to the tap with a piecesingle-phase, 50 Hz supply.
of string or attaching it to the wall.
Check that your domestic electrical installation can
take the maximum load required (2.2 kW), also
taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution.
Should the appliance power supply cable
In a sink drain pipe branch. This branch must beneed to be replaced, this must be carried out
above the trap so that the bend is at least 60 cmby our Service Centre.
above the ground.
Directly into a drain pipe at a height of not lessPlease ensure that when the appliance is
than 60 cm and not more than 90 cm.installed the power supply cable is easily
accessible.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain pipe
must be larger than the outside diameter of the drain
hose.
8 |
ACEC
ZANUSSI
